Mojave 10.14.6, ASUS Prime Z390-A, i9 9900K, iGPU HD630, some problems.

[Syroejkin]

I wish everyone immunity in this chat!
There is such a configuration:
ASUS Prime Z390-A
i9 9900K
iGPU HD630
Corsair DDR4 3200 2x8 Gb
SSD M.2 2280 1Tb Intel 660p Series [SSDPEKNW010T8X1]

Mojave installed using Unibeast, Multibeast, Clover 5108.
There are the following problems after installation.
1. No access to BIOS. After pressing Del or F2 I get a black screen. If I turn off the SSD, then I go into the BIOS settings without problems.
I took out the battery on the motherboard, connected the contacts to reset CMOS - it does not help.

2. I use Lilu 1.4.0 and WhateverGreen 1.3.5 plugins. With these versions, the system boots normally. But if I update the plugins to the latest versions for today (04/11/2020) - 1.3.8 and 1.4.3, I get a DVi No Signal and a black screen after "IOConsoleUsers: gIOScreenLockState 3" with -v bootarg.

Please help solve these problems.

I add EFI to the post.

 

[Syroejkin]

I’ll add to the problems the lack of a built-in Audio device and the fan speeds are not displayed in the system.
Please, help.

 

[chenga732]

Hi Syroejkin,

I got the same motherboard as your but will an i7-9700k and using the IGPU for now. I created the mojave with the unibeast. The system is getting stuck at end of loading with Apple logo. Do you mind saving your bios setting or point me to the site you use. Any help with be great?