Looking for clover advice (seems my graphic card and my cpu not recognized)

[crashphenix]

Hello everybody,
I'm trying to upgrade my yosemite hackitosh, with a fresh install of high sierra on a new SSD (https://www.amazon.com/gp/product/B01IAGSD5O/?tag=tonymacx86com-20)

The first time, i tried the "official" guide with unibeast installation : https://www.tonymacx86.com/threads/...ierra-on-any-supported-intel-based-pc.235474/

But because of installation error "mac os could not be installed on your computer", i tried clover installation method instead.
I also put debug on and unfortunately i have the same error than with unibeast.

I detected at least two problems into debug "please switch to XPC or bootstrap_check_in() and "this is an unknown CPU model 0x34".

I've attached some screenshot and my clover config, i would really appreciate some advices, probably i missed something into clover ?

Cheers !

 

[OhellHD]

Try to put the .kexts also into the 10.13 folder, additionally try to set in boots arguments shikigva=1 to 0 or remove it completle. Had some issues with this boot arg aswell.

Hope I could help, kindest regards

 

[crashphenix]

Thanks @OhellHD !
What did you mean by "put the .kexts also into the 10.13 folder" ?
there are a lot of tools and nobody seems to use the same (clover, unibeast, multibeast, chimera) so i'm a bit lost right now :-/
Kinds regards

 

[OhellHD]

On your EFI drive you navigate to EFI/CLOVER/kexts/10.13 and copy all the stuff that is in your "Others" folder into this one.
Also did you ever get into the system/installer?

EDIT:
I just looked into your EFI file again and I would remove the complete content of EFI/CLOVER/kexts/Others, try to finsh up the installation and install all your kexts after your installation via Multibeast.

Could you walk me through your installation process until now, so I can help you a bit better?
Kindest regards

 

[Gigamaxx]

Hello everybody,
I'm trying to upgrade my yosemite hackitosh, with a fresh install of high sierra on a new SSD (https://www.amazon.com/gp/product/B01IAGSD5O/?tag=tonymacx86com-20)

The first time, i tried the "official" guide with unibeast installation : https://www.tonymacx86.com/threads/...ierra-on-any-supported-intel-based-pc.235474/

But because of installation error "mac os could not be installed on your computer", i tried clover installation method instead.
I also put debug on and unfortunately i have the same error than with unibeast.

I detected at least two problems into debug "please switch to XPC or bootstrap_check_in() and "this is an unknown CPU model 0x34".

I've attached some screenshot and my clover config, i would really appreciate some advices, probably i missed something into clover ?

Cheers !

Try this config.plist

 

[jcds83]

Don't worry about your graphic card GT 640. I have the same and I am under HS 10.13.6. No need of the web drivers from Nvidia too.