ok I Cloned from the 60gb ssd to the 128gb ssd then I ran multibeast and install the Chimera bootloader and the drive boots fine. but I'm not getting great speeds, my Read/Write speeds are very low even after enabling trim. Both ssd's are using 6gbit cable and are both on the sata3 the R/W on the 60GB OCZ Agility 3 are 420 MB/s 390 MB/s but on my new 128GB OCZ Vertex 4 the R/W are 180 MB/s 280 MB/s thats low. any advice on how to bring my speeds back up past 400 MB/s?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.