- Joined
- Feb 26, 2016
- Messages
- 4
- Mac
- Classic Mac
- Mobile Phone
I have an old HP 8300 small form factor (SFF). I successfully installed Sierra 10.12.5 and it was mostly working fine (couldn't get iMessage working but that's a separate issue).
I installed a second hard drive and then installed windows 10 from an installation usb.
Now when I start up, instead of going to Clover boot screen it boots direct to Windows (no Clover screen). Obviously the windows boot has taken priority.
If I disconnect the Windows HDD, I get a windows boot error screen. I can click through a few options and select the clover EFI file, and it will successfully take me to the Clover boot screen and boot from there - so the original EFI for Clover is intact.
How do I fix this so I get back to the normal Clover boot screen - with Windows as a boot option too? I've tried lots of other threads but can't seem to work it out.
My boot options look like below.
If I disable Windows Boot Manager I just get a blinking DOS cursor.
SATA0 is MacOS and SATA2 is Windows 10.
Can anyone help me unravel this knot?
I installed a second hard drive and then installed windows 10 from an installation usb.
Now when I start up, instead of going to Clover boot screen it boots direct to Windows (no Clover screen). Obviously the windows boot has taken priority.
If I disconnect the Windows HDD, I get a windows boot error screen. I can click through a few options and select the clover EFI file, and it will successfully take me to the Clover boot screen and boot from there - so the original EFI for Clover is intact.
How do I fix this so I get back to the normal Clover boot screen - with Windows as a boot option too? I've tried lots of other threads but can't seem to work it out.
My boot options look like below.
If I disable Windows Boot Manager I just get a blinking DOS cursor.
SATA0 is MacOS and SATA2 is Windows 10.
Can anyone help me unravel this knot?
Last edited: