- Joined
- May 11, 2016
- Messages
- 4
- Motherboard
- GA-P55A-UD3R F3
- CPU
- i5-750
- Graphics
- XFX Radeon HD 6970
Hi all,
This is my first attempt at getting a hackintoch going.
I manage to get El Capitan installed to the drive BUT i can only boot into safe mode.
I believe that running Multibeast will help with this but then there is another problem. Multibeast is not able to make any installations in safe mode. all i get is an installation error. This has something to do with permissions, i think. I have googled around and found this information on another site.
The error message is:
05/18/16 18:53:02 - Starting MultiBeast 8.2.2-20160504
05/18/16 18:53:14 - Installing 'Bootloaders > Clover v2.3k r3423 Legacy Boot Mode'
05/18/16 18:53:18 - Install of 'Clover_v2.3k_r3423-Legacy.pkg' failed.
'installer: Package name is Clover v2.3k r3423 EFI bootloader
installer: Upgrading at base path /
installer: The upgrade failed (The Installer encountered an error that caused the installation to fail. Contact the software manufacturer for assistance.)
'. Exiting.
So, the question is then. What can i do to get this working in safe mode?
Or - is there something else i should try?
I am grateful for any comments and help received in this matter
This is my first attempt at getting a hackintoch going.
I manage to get El Capitan installed to the drive BUT i can only boot into safe mode.
I believe that running Multibeast will help with this but then there is another problem. Multibeast is not able to make any installations in safe mode. all i get is an installation error. This has something to do with permissions, i think. I have googled around and found this information on another site.
The error message is:
05/18/16 18:53:02 - Starting MultiBeast 8.2.2-20160504
05/18/16 18:53:14 - Installing 'Bootloaders > Clover v2.3k r3423 Legacy Boot Mode'
05/18/16 18:53:18 - Install of 'Clover_v2.3k_r3423-Legacy.pkg' failed.
'installer: Package name is Clover v2.3k r3423 EFI bootloader
installer: Upgrading at base path /
installer: The upgrade failed (The Installer encountered an error that caused the installation to fail. Contact the software manufacturer for assistance.)
'. Exiting.
So, the question is then. What can i do to get this working in safe mode?
Or - is there something else i should try?
I am grateful for any comments and help received in this matter