iBoot doesn't start!

[daeron]

Hi Guys!

I have a p7h55-m/usb3, i5 750, nvida 7300le, sata3 6gb/s hd.

I followed all the instructions, but I always get the same error.

When I put on the iBoot cd, after the text cursor finished rounding, I read "mounting done", and then I get a blank screen and there's no vga signal anymore.

I tried to switch to the internal vga, but nothing; I tried to switch to sata2 3gb/s but nothing.

What's the problem???

 

[ijhu]

Try "-v" verbose and see what displays on the screen.
Disable onboard VGA graphic....in BIOS....

7300LE graphic...works in 32bits only...
viewtopic.php?f=15&t=12385

 

[daeron]

I tried -v but get the same error.....

In BIOS I can't disable the onboard VGA.....

How can it works in 32 bit mode?

I look at your post's reply and I burned 2 cd: one with the code added to the file, and one replaced, both doesn't boot.

We have to add or replace the code??

Please can you post the entire code so I had just to replace?

 

[daeron]

I burned out a lot of cds....

please somebody can give me the bootable image?

 

[ijhu]

Here's a same board....take a look..see if it helps.
viewtopic.php?f=3&t=11437

 

[SnapMan]

I am not sure the merom t7200 is supported. I couldn't find any reference to it in the forums or in a Google search of merom t7200 hackintosh, excepting one link to installing Tiger that was 4 years old.

You can research it further.....to install Snow Leopard, it needs to support SSE3 and HPET plus probably other standards.

 

[daeron]

Hi Guys!

I have a p7h55-m/usb3, i5 750, nvida 7300le, sata3 6gb/s hd.

I followed all the instructions, but I always get the same error.

When I put on the iBoot cd, after the text cursor finished rounding, I read "mounting done", and then I get a blank screen and there's no vga signal anymore.

I tried to switch to the internal vga, but nothing; I tried to switch to sata2 3gb/s but nothing.

What's the problem???

I don't have a merom t7200...