iBoot 3.3 and Dell Latitude E4310

[ckleea]

Would like to seek more advice in this forum.

I have now been able to install a retail Snow Leopard into the harddisk and book with IBoot 3.3. However, after that I am unable to upgrade or using multibeast to further configure the system.
Once I did so, there is error in the IOPCI Family version.
It did happens when booting iBoot 3.3 but it allows to continue to boot and go to GUI for installation. Also without any upgrading or multibeast, my retail image can start up after loading the iBoot CD first.

 

[ckleea]

My installed image can only boot from iBoot image.

If I use multibeast, it can't boot
If I try to update to 10.6.5, 10.6.6, 10.6.8 from combo update, can't boot (even first boot from iBoot CD)
I then make a 10.6.3 retail install, it boots via i?oot ?? but the mousepad not working. ?gain can't upgrade further