I can´t start Mac OS Sierra after installed audio_cloverALC110 [Solved]

[Roberbond]

hi! I didn´t have sound because there were no audio device. I restored the AppleHDA.kext and I could use the audio_cloverALC110.command. I accepted averything the terminal ask me.

But after reboot there is a kernel panic when I try to acces to the OS. What can I do?

 

[Roberbond]

I can enter the system using safe mode, but I can´t mount the EFI partition

 

[toleda]

Audio does not cause a KP, different problem.
Use UniBeast/USB installer to boot.

 

[Roberbond]

I have the KP after having made the actions I described above.
If I use the unibeast/USB to boot and I choose the Sierra installation afterwards I get the same KP.

 

[Roberbond]

Reinstalled and everything was ok again. This time I used multibeast and I choose the ALC1150 and 100 series audio as recommended... and I got the kernel panic again!!!
Reinstalled again. What can I do? is it better to use the audio_cloverALC110.command or audio_cloverALC120_v10b0.command?

 

[toleda]

If I use the unibeast/USB to boot and I choose the Sierra installation afterwards I get the same KP.

Clearly not an audio problem. Clean install.

 

[Roberbond]

I made a clean install, the I followed your guide to add the audio device and adding the HDEF parameters resolved the problem. Thanks a lot!