hp 250 g3

[Feartech]

no, it's legacy

just seen this:

and the bios settings has mention of UEFI settings around the 6 minute mark

 

[gazaprogamer]

So I should disable legacy support?

 

[Feartech]

So I should disable legacy support?

you should make a new usb installer using UEFI:

[Guide] Booting the OS X installer on LAPTOPS with Clover

Overview One of the first challenges you'll face in installing OS X to your laptop will involve getting the OS X installer to boot from USB. This guide is for those wishing to use Clover (and in fact the only bootloader supported here). Both installing using Clover UEFI and Clover legacy are...

www.tonymacx86.com

 

[gazaprogamer]

you should make a new usb installer using UEFI:

[Guide] Booting the OS X installer on LAPTOPS with Clover

Overview One of the first challenges you'll face in installing OS X to your laptop will involve getting the OS X installer to boot from USB. This guide is for those wishing to use Clover (and in fact the only bootloader supported here). Both installing using Clover UEFI and Clover legacy are...

www.tonymacx86.com

So disable legacy and create a new installer using uefi

 

[gazaprogamer]

you should make a new usb installer using UEFI:

[Guide] Booting the OS X installer on LAPTOPS with Clover

Overview One of the first challenges you'll face in installing OS X to your laptop will involve getting the OS X installer to boot from USB. This guide is for those wishing to use Clover (and in fact the only bootloader supported here). Both installing using Clover UEFI and Clover legacy are...

www.tonymacx86.com

By the way it now says this in the middle of the installation

 

[Feartech]

By the way it now says this in the middle of the installation View attachment 397143

check your bios settings:
To start, set BIOS to defaults.

Then insure:
- UEFI boot is enabled (hybrid/with CSM for best result)
- secure boot is disabled
- disable fast boot
- IGPU graphics memory set to 64mb, if available
- disable the serial port via BIOS option, if available
- disable "LAN/WLAN switching", if available
- disable "Extended Idle Power States" if you find it under "Power Management Options"
- disable "Wake on LAN" and "Wake on USB"
- disable Firewire/IEEE 1394, if your laptop has it
- for Skylake and KabyLake laptop, enable "Launch Hotkeys without Fn keypress"

 

[gazaprogamer]

check your bios settings:
To start, set BIOS to defaults.

Then insure:
- UEFI boot is enabled (hybrid/with CSM for best result)
- secure boot is disabled
- disable fast boot
- IGPU graphics memory set to 64mb, if available
- disable the serial port via BIOS option, if available
- disable "LAN/WLAN switching", if available
- disable "Extended Idle Power States" if you find it under "Power Management Options"
- disable "Wake on LAN" and "Wake on USB"
- disable Firewire/IEEE 1394, if your laptop has it
- for Skylake and KabyLake laptop, enable "Launch Hotkeys without Fn keypress"

Alright, I will try to create a new USB using uefi

 

[Feartech]

Alright, I will try to create a new USB using uefi

that would probably be best

 

[gazaprogamer]

that would probably be best

Now I have to install windows again

 

[gazaprogamer]

Edit thread name to hp 250 G4