- Joined
- Jul 23, 2011
- Messages
- 45
- Motherboard
- GA-Z68MX-UD2H-B3 (Rev. 1.0)
- CPU
- i7 2600k
- Graphics
- XFX Radeon 6870 1GB
- Mobile Phone
I have a bad RAM module and in order to get a warranty replacement, I have to perform a memory test with memtest86. The problem is, my system information shows all the hackintosh stuff and that's not going to fly with Corsair. How do I revert my System Information back to the default ASUS values?
Tbh I haven't booted into mac in over two years and I've forgotten what a lot of the terminology is. I used Clover Configurator to set these values. As you can see, I used Unibeast (multibeast+clover) to install OSX - I'm looking to remove all remnants of it and start over fresh once I get my memory issue resolved! I'm not sure how to get this info back to default values.
I'm not sure if this info is coming from EFI or what. I can see the values in the registry, but before I start messing with those values I'd like to know where they are coming from, otherwise I suspect they will come right back.
Tbh I haven't booted into mac in over two years and I've forgotten what a lot of the terminology is. I used Clover Configurator to set these values. As you can see, I used Unibeast (multibeast+clover) to install OSX - I'm looking to remove all remnants of it and start over fresh once I get my memory issue resolved! I'm not sure how to get this info back to default values.
I'm not sure if this info is coming from EFI or what. I can see the values in the registry, but before I start messing with those values I'd like to know where they are coming from, otherwise I suspect they will come right back.