HELP with ASUS X551C

[RehabMan]

I have an upgrade
asus bios can create a boot point to the efi partition but only if efi partition is fat32
so i changed the command newfs_hfs to newfs_msdos

then i tryed to copy clover files to the efi partition using terminal
and when i boot without usb stick i see the new clover boot disks
but something wrong because if i select my maverick , it give me a timeout error
but im close to the solution

maybe Clover is not the right choice for bootloader

i try

Setting up Clover can be complex. You might refer to this guide for the ProBook and borrow some of the files/procedures there: http://www.tonymacx86.com/hp-probook-mavericks/112383-guide-install-mavericks-clover-bootloader.html

 

[giampy72]

Yes you are right
do you tHink its possible install a bootloader like chimera in my efi fat32 partition?

 

[RehabMan]

Yes you are right
do you tHink its possible install a bootloader like chimera in my efi fat32 partition?

You could try it.

 

[giampy72]

Im thinking to try easybcd with win8 dualboot

 

[giampy72]

Setting up Clover can be complex. You might refer to this guide for the ProBook and borrow some of the files/procedures there: http://www.tonymacx86.com/hp-probook-mavericks/112383-guide-install-mavericks-clover-bootloader.html

success!!

i install clover bootloader with my intelhd4000 works , thanks to you
now i can work on audio , mousepad , and wifi
im studing clover and where put my kext
can you help me?

 

[RehabMan]

success!!

i install clover bootloader with my intelhd4000 works , thanks to you
now i can work on audio , mousepad , and wifi
im studing clover and where put my kext
can you help me?

For kexts you're going to use permanently with your normal install, place them in /System/Library/Extensions just like you would normally.

EFI/CLOVER/kexts/10.9 (etc) are for kexts required to boot the recovery partition only. Typically FakeSMC, PS2 kext, NullCPUPowerManagement, and perhaps networking kexts.

 

[giampy72]

My kext are in S/L/E
for expample
if i boot hdd with my usb bootloader i can see audio works , but if i boot with clover , audio doesnt works and mousepad stop to work too

maybe there is something to activate or deactivate in config.plist file

 

[RehabMan]

My kext are in S/L/E
for expample
if i boot hdd with my usb bootloader i can see audio works , but if i boot with clover , audio doesnt works and mousepad stop to work too

Is your USB clover-based?

maybe there is something to activate or deactivate in config.plist file

Not really. Check that your kexts are loaded using kextstat.

 

[giampy72]

Writing kextstat i dont see voodoohda and battery
hmmm somethings wrong

 

[giampy72]

I saved two file about kextstat
one booting with usb unibeast then select hdd
and
one booting with clover
they are little different
for ex. with clover
I dont see voodoohda

so i think there is something to set in config.plist to say to load sle