Help! UniBeast won't continue loading. Not able to create a bootable USB Drive

[stevenzv]

So I was just preparing my USB Drive for the OS X Yosemite installation for my Hackintosh I followed tonymacx86's Guide I created the bootable USB Drive using Disk Utility and then ran UniBeast I checked everything until the part with the password and clicked Install. Then the loading bar just go stuck at that position ( Screenshots underneath ). After waiting for around 10 minutes I closed UniBeast and ejected the USB. I wanted to try it again so I put my USB back in and went to the Disk Utility again and now there are some other drives visible and I don't know what they are ( see Screenshots ). I partitioned the USB again and tried it again with UniBeast and again it got stuck at the same place. What should I do now? try it on another mac or am I doing something wrong? btw I'm using a MacBook Pro (13-inch, Early 2011) on version 10.10.5.

 

[P1LGRIM]

After waiting for around 10 minutes I closed UniBeast and ejected the USB.

am I doing something wrong?

You need a bit more patience, it takes a lot more than 10 minutes.

http://www.tonymacx86.com/unibeast/144899-unibeast-5-troubleshooting-notes.html

 

[stevenzv]

Ok I'll give it another shot thanks