Help me make proper CLOVER USB for Mavericks

[Baraq]

Can you help me make proper CLOVER USB for Mavericks?

GA-Z97MX-Gaming 5
i7 4790k
32 GB RAM
1 TB Samsung SSD
8 TB RAID 0 Seagate 4 TB x 2
On-board Graphics

 

[VioletDragon]

Can you help me make proper CLOVER USB for Mavericks?

GA-Z97MX-Gaming 5
i7 4790k
32 GB RAM
1 TB Samsung SSD
8 TB RAID 0 Seagate 4 TB x 2
On-board Graphics

Take a look at 10.9 Installation.

 

[Baraq]

Thanx a million @VioletDragon

I was able to install Mavericks and get to the Desktop. I have to boot with -v -x
to get to the Desktop.

Working on getting Hard Drive to boot on it's on by moving some Kext around. Boot keeps getting stuck
@drm iTunes. I'll keep you posted.

Question: Should i use MacPro3,1 or iMac14,2 like I use for El Capitan & Sierra?

Here is my config.plist with Mac pro 3,1

 

[VioletDragon]

Thanx a million @VioletDragon

I was able to install Mavericks and get to the Desktop. I have to boot with -v -x
to get to the Desktop.

Working on getting Hard Drive to boot on it's on by moving some Kext around. Boot keeps getting stuck
@drm iTunes. I'll keep you posted.

Question: Should i use MacPro3,1 or iMac14,2 like I use for El Capitan & Sierra?

Here is my config.plist with Mac pro 3,1

Your config.plist is broken. Try the one attached.

 

[Baraq]

Ok. Be right back.

 

[Baraq]

Made it to the Desktop using USB with boot flags -v -x.

I installed CLOVER Clover_v2.4k_r4097, deleted config.plist and replaced with yours, I
put FakeSMC, NullPowerManagement and AtherosE2200Ethernet Kext in EFI partition inside
kext folder 10.9... Restarted machine and now i'm stuck at Missing Bluetooth Controller Transport!

Please Help!

I can reach the desktop when I use boot flags -v -x. Something needs to come out but I cannot figure it out!

 

[VioletDragon]

Made it to the Desktop using USB with boot flags -v -x.

I installed CLOVER Clover_v2.4k_r4097, deleted config.plist and replaced with yours, I
put FakeSMC, NullPowerManagement and AtherosE2200Ethernet Kext in EFI partition inside
kext folder 10.9... Restarted machine and now i'm stuck at Missing Bluetooth Controller Transport!

Please Help!

Yes my bad. Put SSDT-IGPU in EFI/Clover/ACPI/patched. FYI NullCPUPowermanagement is not needed.

 

[Baraq]

Here are the screenshots of my installer EFI partition and all the kext.

 

[Baraq]

Ok. Be right back!

 

[Baraq]

I'm stuck at DRMStaus..... Error Code: 8877652

Single view are Kext on my usb. Two pane view is my Main drive.