Help![hack]El capitan loop reboot after first installation.

[Nazgul91]

Hi
I'm new member and this is the first time I write on the forum. Sorry for my bad English I'm Italian.
I would like install hackintosh to try this OS X,because I never work with this SO. I asked a friend to lend his MacBook Pro with Snow Leopard. I have followed the guide of forum and I create USB key with El capitan. I have installed operating system but when I restart for first time OS,it reboot. I used flag boot "-v" and OS reboot with these message:
Warning IOPlatformPluginUtil getCPUIDinfo
IObluetoothFamily[start] -completed
I have my graphics card connect with monitor throught VGA cable(I use adapter DVI-VGA).
I don't know how to continue. Please Can you help me?Please can you explain step by step all procedures?
Thanks
MoboGigabyte H97 HD3(with last BIOS rev.)CPUIntel i7 4790kGraphicsAsus Strix Gtx960RAM G Skill ares 1600 cl9 4x8Gb

 

[linuxrox]

How far did you get in this guide ?

http://www.tonymacx86.com/el-capita...-el-capitan-any-supported-intel-based-pc.html

 

[Nazgul91]

I Arrived paragraph 4-8

 

[Nazgul91]

I have forgot,this is my BIOS setup:
Intel virtualization tecnology=enabled
vt-d=disable
XHCI mode=enabled
Intel processor graphics=enabled (graphics card of motherboard)
Intel rapid star tecnology=enabled
XHCI hand-off=enabled
EHCI hand-off=enabled
Legacy usb support=enabled
Maybe this configuration generate an error IObleutoothFamily?

 

[Nazgul91]

I solved a problem. I leave a solution for other people that they have neccesity. After I reboot the installation I insert bootflag nv_disable=1 -v and I disconnect adapter DVI>VGA and connect HDMI,and it's works.