RehabMan
Moderator
- Joined
- May 2, 2012
- Messages
- 181,016
- Motherboard
- Intel DH67BL
- CPU
- i7-2600K
- Graphics
- HD 3000
- Mac
- Mobile Phone
Okay, so if I were to go the route of customizing all of the above, and I use this template I found on your repo as a starting point, if I'm understanding this right, I would rename "HUB1", Package() to match the DSDT name of my hub device; same for ports. USBConnector should match the value for the port definition found in the DSDT and ACPI spec. What is porttype? Port count is obviously the number of ports being defined, correct?
Use the template. No renaming involved (why do people think that is a good idea?)
portType is not understood.
port-count is the maximum port address (if specified), nothing to do with any 'count'.