Gigabyte Z390 M Gaming build with working NVRAM

[esse]

That image on the pdf is from my EFI????

I don't know what "deflag" is...

I still don't know what you're talking about. Please post a screenshot.

Make sure you are using the latest OpenCore EFI. Don't use old config.plists with new EFIs.

Sorry, finally found where edit verbose in config,
and this is:

 

[pastrychef]

Sorry, finally found where edit verbose in config,
and this is:

Make sure you have config.plist > Misc > Security > SecureBootModel > Disabled.

 

[esse]

Make sure you have config.plist > Misc > Security > SecureBootModel > Disabled.

Sorry but in config.plist > Misc > Security there's no SecureBootModel
I'm using your EFI OpenCore 0.6.3 Z390M

 

[pastrychef]

Sorry but in config.plist > Misc > Security there's no SecureBootModel
I'm using your EFI OpenCore 0.6.3 Z390M

 

[esse]

Nothing, doesn't work, always stopped at the same point...
...really strange cause the clover one EFI Clover r5126 Z390M v2 works fine (except shutdown)
I'm on mb_bios_z390-m-gaming_f9l

(btw thank u so much for the time you spent with me mate!)

 

[pastrychef]

Nothing, doesn't work, always stopped at the same point...
...really strange cause the clover one EFI Clover r5126 Z390M v2 works fine (except shutdown)
I'm on mb_bios_z390-m-gaming_f9l

(btw thank u so much for the time you spent with me mate!)

Are you getting to the OpenCore boot menu?

If yes, try selecting the Recovery partition. Then re-install macOS on top of your current installation.

Also, make sure you downloaded OpenCore 0.6.3 EFI.

 

[esse]

Are you getting to the OpenCore boot menu?

If yes, try selecting the Recovery partition. Then re-install macOS on top of your current installation.

Also, make sure you downloaded OpenCore 0.6.3 EFI.

Yes OpenCore boot menu works, Recovery doesn't...
The only thing I use is your efi folder:

 

[pastrychef]

The only thing I use is your efi folder

Are you booted in to macOS now?

 

[esse]

Are you booted in to macOS now?

No...i'm on my macbook
I can boot the rig with Clover...but no wifi (i have an old TPLINK TL-WDN4800)

 

[pastrychef]

No...i'm on my macbook
I can boot the rig with Clover...but no wifi (i have an ol TPLINK TL-WDN4800)

Download the OpenCore 0.6.3 EFI again from post #1.
Put it on the EFI partition of a USB flash drive.
Boot from the USB flash drive.
Select macOS at the OpenCore boot menu.

I don't know anything about the the TPLINK. I've never used one and I don't know what chipset they use or whether or not they need special drivers.