ga-z77x-ud5h hangs after multiboot

[chemdream78]

Hi all!

I have a ga-z77x-ud5h 3770k, M4, using HD4000 graphics.

I can install 10.8.1 fine. However, after Multibeast, it hangs at boot.

Right now it's hanging at macx_swapon SUCCESS

I've chosen 898 realtek drivers, graphicsEnable=no, install bootloader, and that's it.

Any ideas? Obviously it is not the macx_swapon causing the error, it is whatever comes after.

Thanks!

 

[Asus-Freak]

FakeSMC:

FakeSMC.kext is the only absolutely mandatory kext, and is required for booting the system. Original by netkas, new branch by Project OS X. Installs FakeSMC.kext in /System/Library/Extensions/.

 

[Going Bald]

FakeSMC:

FakeSMC.kext is the only absolutely mandatory kext, and is required for booting the system. Original by netkas, new branch by Project OS X. Installs FakeSMC.kext in /System/Library/Extensions/.

@kdvernay

He has Fakesmc. If he did not he would never have gotten to mac swapon success.

@chemdream78

Did you see Waiting for DSMOS or DSMOS has arrived

 

[chemdream78]

Hey there. It's not in front of me now, but I will check for that.

No matter what I do, it seems like it won't boot afterwards.

I'll check that out asap. Thanks!

 

[chemdream78]

Is it possible there is something in my bios that I should be disabling? It's in AHCI mode.

Dual bios enabled.

I looked at blogs and set bios settings just like everyone elses.

Only using the built in intel graphics.



I actually tried to install Protools HD 8 software before multibeat one time... at the end of the install it totally froze and wouldn't reboot. heh.

I really don't know what I could be doing wrong. I mean other people have this exact same MB with exact same HD and have it working with Multibeast...

 

[Asus-Freak]

@kdvernay

He has Fakesmc. If he did not he would never have gotten to mac swapon success.

Thanks, the thought was

I've chosen 898 realtek drivers, graphicsEnable=no, install bootloader, and that's it

I've seen many post of people not choosing Easybeast or User DSDT, and choosing Bootloader only...

 

[chemdream78]

kduvernay, you were right!

Not using either DST or Easy worked! Just Bootloader.

It did say it failed, but it seemed like it worked.

I didn't install any other drivers, so I need to start over again and do that.

What mac do you guys suggest I set it to emulate so I get higher resolution?

Thanks again!

 

[chemdream78]

Thanks, the thought was I've seen many post of people not choosing Easybeast or User DSDT, and choosing Bootloader only...

On another note,

this does lead me to ask a question that no other Noob has asked.

How is ML booting properly the first time, but doesn't boot correctly again unless you use multibeast?

IE: what is changing in that time?