GA-Z77-DS3H Multibeast settings!

[UnKnown737418]

Hello,

When I boot up my new build, will I need a DSDT for a GA-Z77-DS3H motherboard? Or should I select DSDT free installation?

I'm using the buying guide as a rough starting point so might upgrade in the future. But I'm just confused as to what options I select in Multibeast?

Thanks

 

[P1LGRIM]

Select DSDT free installation

 

[UnKnown737418]

Select DSDT free installation

Thanks, what other options are essential to select? I've searched but can't find any existing examples.

 

[P1LGRIM]

Take a look here : http://www.tonymacx86.com/golden-bu...ild-i7-3770k-ga-z77-ds3h-16gb-ram-6850-a.html

 

[UnKnown737418]

Take a look here : http://www.tonymacx86.com/golden-bu...ild-i7-3770k-ga-z77-ds3h-16gb-ram-6850-a.html

Thanks, some of the pictures are missing, especially the multibeast settings. Are they down for good or is it my computer?

 

[P1LGRIM]

They are temporarily missing because Loginfailed's bandwidth has been exceeded - When his new monthly limit kicks in they will reappear, keep checking back.

 

[mustang80]

If you have revision 1.0

in BIOS:
Load optimised defaults
Disable Virtualisation
Set SATA mode as AHCI

Install as usual

Multibeast
Check DSDT-Free Installation
Audio> Without DSDT> ALC887 / 888b > v100302 Current
Disk > 3rd Party SATA > TRIM enabler
Misc > FakeSMC Plugins > Motherboard Plugins > HW monitor
Network > Atheros


You should be ok with that I think!

 

[P1LGRIM]

I have the same board (The 1.0 version) and these are my Multibeast settings :


Multibeast
UserDSDT or DSDT-Free Installation
Drivers & Bootloaders
Drivers
Audio
Realtek ALC8xx
Without DSDT
ALC887/888b
v100302 Current
Disk
IOAHCIBlockStorageInjector

Network
Atheros

Bootloaders
Chimera v1.11.1 r1394

Customisation
SSDT Options
Sandy Bridge Corei5

 

[UnKnown737418]

They are temporarily missing because Loginfailed's bandwidth has been exceeded - When his new monthly limit kicks in they will reappear, keep checking back.

Okay thanks! Will keep checking back

 

[UnKnown737418]

I have the same board (The 1.0 version) and these are my Multibeast settings :


Multibeast
UserDSDT or DSDT-Free Installation
Drivers & Bootloaders
Drivers
Audio
Realtek ALC8xx
Without DSDT
ALC887/888b
v100302 Current
Disk
IOAHCIBlockStorageInjector

Network
Atheros

Bootloaders
Chimera v1.11.1 r1394

Customisation
SSDT Options
Sandy Bridge Corei5

ACE! Thanks for that. Is the Chimera bootloader essential/what enables OS X to boot up each time you start the computer?

And for "Network" I plan on using a TP-Link WDN4800. Any settings need to be changed for that?