GA-Z77-DS3H 10.8 boots only on -x

[Khor]

Hello all, i just got my new mobo the z77-ds3h v1.1 i did a clear install with -v -x using internal gpu.
after installing multibeast with kext as listed on forums i always need to boot on -x or i get KP on boot.
What should i check?

 

[RehabMan]

Hello all, i just got my new mobo the z77-ds3h v1.1 i did a clear install with -v -x using internal gpu.
after installing multibeast with kext as listed on forums i always need to boot on -x or i get KP on boot.
What should i check?

What is the KP? (show photo).
What did you install with Multibeast?
What version of ML?

 

[Khor]

KP: Kernel Panic on boot
installed 10.8.0 from unibeast
and this is the multibeast config (attached)
ATM i'm updating 10.8 to 10.8.5 to see if something changes

 

[RehabMan]

KP: Kernel Panic on boot

I realize that, but what is the KP from? Take a quality photo of the screen.

BTW, I would avoid FakeSMC PlugIns on the first go-around.

 

[Khor]

So here's the screen, i can do even a screen in verbouse if you need.
I just deleted /Extra folder and wait for some news on what kext choose

 

[RehabMan]

So here's the screen, i can do even a screen in verbouse if you need.
I just deleted /Extra folder and wait for some news on what kext choose

AppleTyMCEDriver.kext panic is caused by your MacPro5,1 sysdef and the fact that you don't have ECC memory (at least that's what I read).

Either change your sysdef to MacPro3,1 or remove/rename /System/Library/Extensions/AppleTyMCEDriver.kext.

You will need your /Extra folder back. Or start over.

 

[Khor]

gonna work on it tomorrow. I will update you thanks!