Ga-b85m-hd3

[bmgp.95]

theres a lot of problems so id recommend staying with the dedicated GPU at the moment

Ok, Installed and restarted. Wouldn't boot with just GraphicsEnabler=no, had to use -v as well or else I got a similar screen to what i had initially without graphics card.

Downloaded multibeast, unsure what settings to use now that I dont have the D3H instructions to go off. Any ideas?

 

[VioletDragon]

you can try these settings only use trim if you have a SSD report back after

 

[bmgp.95]

you can try these settings only use trim if you have a SSD report back after

Install, and then reboot without USB key in?

 

[VioletDragon]

take out the Unibeast pen drive and boot with just -v and see if it boots or gets stuck but make sure you run Multibeast

 

[bmgp.95]

take out the Unibeast pen drive and boot with just -v and see if it boots or gets stuck but make sure you run Multibeast

Thanks for your patience!

got a bunch of warnings from system prefs when multibeast was installing.

rebooted with -v and boot stopped at attached screen

 

[VioletDragon]

has it loaded anymore?

 

[bmgp.95]

has it loaded anymore?

No, still waiting.

 

[VioletDragon]

give this ago
Set XHCI mode to disabled
then boot with GraphicsEnabler=No -x -v npci=0x3000
remove GenericUSBHCXI.kext from extra/extensions folder of the USB drive
then reinstall OSX give it ago then
for Multibeast
FakeSMC
FakeSMCPlugins- Plugins, HWMonitor Application
Audio Realtek ALC887/888b
Network Realtek RTL81xxx
Bootloaders Chimera 3.0.1

 

[bmgp.95]

give this ago
Set XHCI mode to disabled
then boot with GraphicsEnabler=No -x -v
remove GenericUSBHCXI.kext from extra/extensions folder of the USB drive
then reinstall OSX give it ago then
for Multibeast
FakeSMC
FakeSMCPlugins- Plugins, HWMonitor Application
Audio Realtek ALC887/888b
Network Realtek RTL81xxx
Bootloaders Chimera 3.0.1

Thanks!

I just came across this which is multibeast settings for this board. Is there a way to get back into OS X without re installing completely to try those? Or do you recommend the steps you just listed first?

Thanks again!

 

[VioletDragon]

no you will have to reinstall make sure you boot into safe mode first and remove that kext file from your Unibeast Pendrive and by all means you can give it ago it won't hurt to try it