- Joined
- May 10, 2014
- Messages
- 41
- Motherboard
- Gigabyte GA-Z87M-D3H
- CPU
- i7-4770K
- Graphics
- AMD 5700 XT 8GB
- Mac
- Mobile Phone
I am doing a fresh install (after unstable machine) to 10.12 but now I can't get it to restart or shutdown properly, after post-installation pf Multibeast. The screen will turn black , with only my mouse cursor active.
ALC892 audio was also not detected after installing it with Multibeast. This was the same installation procedure I did with success but this time, it does not work. Hardware config is in my signature.
Attached is my config.plist from Clover.
Any advise is greatly appreciated. Thanks.
p/s I have searched entire forum and tried almost ALL procedures, but lost 2 days already.
[updated config]
ALC892 audio was also not detected after installing it with Multibeast. This was the same installation procedure I did with success but this time, it does not work. Hardware config is in my signature.
Attached is my config.plist from Clover.
Any advise is greatly appreciated. Thanks.
p/s I have searched entire forum and tried almost ALL procedures, but lost 2 days already.
[updated config]
Attachments
Last edited: