Clover and MultiBeast Help Please

[terpsy]

I have installed a Clover build on the following Hardware

Gigabyte B85M-HD3
i5 4670k
Seagate 2TB HD
Asus Nvidia 760 GTX

I am concerned about the plist for the computer and do not want to make
an error woth the Clover Configurator.

I have tried to find more information and the wiki, but as confused at both still.

Can I run Multibeast on the machine, and not install the Bootloader portion of it?

Will I be ruining another of the Clover build by doing so?

If I run Multibeast, which files should I then copy to the EFI boot partition?

Thank you for your Help!

 

[Jithin.C.V]

I have installed a Clover build on the following Hardware

Gigabyte B85M-HD3
i5 4670k
Seagate 2TB HD
Asus Nvidia 760 GTX

I am concerned about the plist for the computer and do not want to make
an error woth the Clover Configurator.

I have tried to find more information and the wiki, but as confused at both still.

Can I run Multibeast on the machine, and not install the Bootloader portion of it?

Will I be ruining another of the Clover build by doing so?

If I run Multibeast, which files should I then copy to the EFI boot partition?

Thank you for your Help!

If you want to use clover as your bootloader, then install clover and make the system bootable.

Once it is successfully booted from HDD, you can install required kexts from MultiBeast too.

 

[terpsy]

Thank you.

Just to make so I understand fully

Which files do I need to copy to the EFI boot partition
to have a minimal boot? and where should I grab them from?

Do I have to replace my config.plist that is created when I do the install of OS X ?

Thanks!

 

[Jithin.C.V]

Which files do I need to copy to the EFI boot partition
to have a minimal boot?

For minimal boot only FakeSMC.kext and correct config.plist is enough

here should I grab them from?

For FakeSMC.kext : https://bitbucket.org/RehabMan/os-x-fakesmc-kozlek/downloads/RehabMan-FakeSMC-2015-0504.zip

config.plist you will get it from this forum's clover guide (May required some changes as per what hardware configuration you have)

Note:- If your keyboard/mouse is connected to PS2 port, then add this kext too : https://bitbucket.org/RehabMan/os-x-voodoo-ps2-controller/downloads/RehabMan-Voodoo-2015-0502.zip

Do I have to replace my config.plist that is created when I do the install of OS X ?

OS X install will not store any config.plist, this is will present after clover installation. The default config.plist may not be appropriate for your hardware configuration. You may have to do change on it.