- Joined
- Mar 19, 2017
- Messages
- 1
- Motherboard
- No
- CPU
- No
- Graphics
- No
Hello there,
after I found a solution to my problem of MacOS not supporting the Nvidia GTX1070 (or Nvidia not supporting MacOS?) I tried installing it again. Instead of using a non-hardware accelerated PCIe GPU and only one screen I'd like to use my onboard Intel HD4600 graphics adapter to power two monitors. Ultimately I want to dual boot Windows and MacOS and have Windows powered by my GTX and Mac by the HD4600.
I've installed MacOS on a separate SSD after formatting it with a new MacOS Journal (Extended) Partition with the GUID scheme. Additionally in my computer are a separate SSD I'm using for Windows and a Hard Drive. I then ran MultiBeast and chose UEFI Boot Mode, a Realtek Network driver and the Clover UEFI Bootloader. When trying to boot my computer from that drive it just displays the message "Reboot and select proper Boot device". I only manage to get into the Clover menu when booting from the USB drive I used to install MacOS.
My system:
Intel i5 4690K
ASRock Z97M Anniversary
EVGA GTX 1070 SC
32GB DDR-1666MHz RAM
This is the drive according to diskutil:
Please let me know if you need any additional info. Thanks for any help!
after I found a solution to my problem of MacOS not supporting the Nvidia GTX1070 (or Nvidia not supporting MacOS?) I tried installing it again. Instead of using a non-hardware accelerated PCIe GPU and only one screen I'd like to use my onboard Intel HD4600 graphics adapter to power two monitors. Ultimately I want to dual boot Windows and MacOS and have Windows powered by my GTX and Mac by the HD4600.
I've installed MacOS on a separate SSD after formatting it with a new MacOS Journal (Extended) Partition with the GUID scheme. Additionally in my computer are a separate SSD I'm using for Windows and a Hard Drive. I then ran MultiBeast and chose UEFI Boot Mode, a Realtek Network driver and the Clover UEFI Bootloader. When trying to boot my computer from that drive it just displays the message "Reboot and select proper Boot device". I only manage to get into the Clover menu when booting from the USB drive I used to install MacOS.
My system:
Intel i5 4690K
ASRock Z97M Anniversary
EVGA GTX 1070 SC
32GB DDR-1666MHz RAM
This is the drive according to diskutil:
Code:
/dev/disk0 (internal, physical):
#: TYPE NAME SIZE IDENTIFIER
0: GUID_partition_scheme *128.0 GB disk0
1: EFI EFI 209.7 MB disk0s1
2: Apple_HFS MacOS SSD 127.2 GB disk0s2
3: Apple_Boot Recovery HD 650.0 MB disk0s3
Please let me know if you need any additional info. Thanks for any help!