Boot graphics issue 10.12.4

[BHigh17]

I updated to 10.12.4 last night but my install is now stalling at the apple logo. This was the first reboot upon updating. I have attached images of my verbose boot. Thanks!

 

[RehabMan]

I updated to 10.12.4 last night but my install is now stalling at the apple logo. This was the first reboot upon updating. I have attached images of my verbose boot. Thanks!
View attachment 245836 View attachment 245837 View attachment 245838 View attachment 245839 View attachment 245840

Read FAQ, "Problem Reporting"
https://www.tonymacx86.com/threads/faq-read-first-laptop-frequent-questions.164990/

 

[BHigh17]

Here are my verbose boot screenshots and my EFI/CLOVER folder

 

[RehabMan]

Here are my verbose boot screenshots and my EFI/CLOVER folder

Try booting with a "clean" Clover setup. You have a lot of patches that are not even for 10.12 (you should remove them, or tag them with MatchOS as appropriate).

And you have patched ACPI (but incorrectly).

Brightness with IntelBacklight.kext or ACPIBacklight.kext doesn't work, so it could be a graphics issue.

And some of your kexts in Clover/kexts are old...

See Clover guide:
https://www.tonymacx86.com/threads/guide-booting-the-os-x-installer-on-laptops-with-clover.148093/

I think your copy of Clover is also too old for 10.12.4.

 

[BHigh17]

Try booting with a "clean" Clover setup. You have a lot of patches that are not even for 10.12 (you should remove them, or tag them with MatchOS as appropriate).

And you have patched ACPI (but incorrectly).

Brightness with IntelBacklight.kext or ACPIBacklight.kext doesn't work, so it could be a graphics issue.

And some of your kexts in Clover/kexts are old...

See Clover guide:
https://www.tonymacx86.com/threads/guide-booting-the-os-x-installer-on-laptops-with-clover.148093/

I think your copy of Clover is also too old for 10.12.4.

Thanks for the response! Is is possible to update clover through Windows?

 

[RehabMan]

Thanks for the response! Is is possible to update clover through Windows?

The EFI partition is FAT32, therefore can be modified in Windows. It is a bit tricky though, as modifying EFI requires elevated privileges. If you're comfortable with the command line, no problem...