BCM94360CD Disconnect problem

[chemary85]

Hi, anyone have same issues with BCM94360CD Wifi+Bt4.0 card? In El Capitan works OOB.

When macOS loads, it turn on correctly, but after same seconds begins turn off, turn on, turn off, turn off a few times until disconnect completely and can't turn on again. BT works fine, but wireless don't.

Any ideas?

Thanks in advance!

 

[jhonizzle]

Hi, anyone have same issues with BCM94360CD Wifi+Bt4.0 card? In El Capitan works OOB.

When macOS loads, it turn on correctly, but after same seconds begins turn off, turn on, turn off, turn off a few times until disconnect completely and can't turn on again. BT works fine, but wireless don't.

Any ideas?

Thanks in advance!

I have this exact same issue, and same card. Still haven't found a solution. But I will post if I find/figure it out.

 

[chemary85]

I have this exact same issue, and same card. Still haven't found a solution. But I will post if I find/figure it out.

Cool, thanks, i still searching a solution, but not lucky.

 

[jhonizzle]

Cool, thanks, i still searching a solution, but not lucky.

Ok well I've found a "solution" but it's not really a proper one yet. In your Clover config.plist if you swap your board-id to "Mac-2E6FAB96566FE58C" wireless will work flawlessly. However on my build doing this breaks graphics so I have to boot with nv_disable=1. So it seems it should just be a simple Kext Patch with board-id's i.e. swapping in my case Mac Pro 6,1 for MacBook Air 5,2... however I've tried this and it hasn't worked. So for now still trying to figure it out.

Edit: it's something other than AirPortBrcm4360 that is being changed....what it is... I have no idea

 

[chemary85]

Ok well I've found a "solution" but it's not really a proper one yet. In your Clover config.plist if you swap your board-id to "Mac-2E6FAB96566FE58C" wireless will work flawlessly. However on my build doing this breaks graphics so I have to boot with nv_disable=1. So it seems it should just be a simple Kext Patch with board-id's i.e. swapping in my case Mac Pro 6,1 for MacBook Air 5,2... however I've tried this and it hasn't worked. So for now still trying to figure it out.

Edit: it's something other than AirPortBrcm4360 that is being changed....what it is... I have no idea

MMM, this board-id how smbios is based? I use MacPro6,1 but my graphics works ok, so i need to use nv_disable until install nvidia web drivers, after install it, you have to patch AppleDevicePolicyGraphics, (use piker alpha app). Run it, and restart.

This night will try this board-id. Thanks dude!

 

[mdlfans]

the problem had fixed?