- Joined
- Jul 26, 2011
- Messages
- 27
- Motherboard
- Z68MA-D2H-B3
- CPU
- Intel i5
- Graphics
- ATI Fireproof V4800
- Mac
- Classic Mac
- Mobile Phone
I am quite close to success on Lion for my ATI Firepro V4800 card.
My card has 2 display port and 1 DVI port
I installed 10.7.1 and connect the monitor to a display port.
When I boot it from Chimera, it show a word on left top corner "Unsupported card"
Then I only could use 1024x768 with "no kext loaded" on my Graphics/Display from System Profiler.
Then read the forum many times, I tried to add my Device ID in ATI5000Controller.kext then run the MultiBeast - System Utilities.
Then it still has "Unsupported card" but black screen.
When I see the hard disk light, it is running and I try to use a VGA cable connect to the DVI port, it shows perfect for me.
I can use DVI port connect to VGA input of my monitor with full resolution but I cannot use display port or DVI port connect to the monitor screen (Black screen).
I have tried to use AtiPorts=3 but it does not work.
I did not change any framebuffer on the above testing.
My card has 2 display port and 1 DVI port
I installed 10.7.1 and connect the monitor to a display port.
When I boot it from Chimera, it show a word on left top corner "Unsupported card"
Then I only could use 1024x768 with "no kext loaded" on my Graphics/Display from System Profiler.
Then read the forum many times, I tried to add my Device ID in ATI5000Controller.kext then run the MultiBeast - System Utilities.
Then it still has "Unsupported card" but black screen.
When I see the hard disk light, it is running and I try to use a VGA cable connect to the DVI port, it shows perfect for me.
I can use DVI port connect to VGA input of my monitor with full resolution but I cannot use display port or DVI port connect to the monitor screen (Black screen).
I have tried to use AtiPorts=3 but it does not work.
I did not change any framebuffer on the above testing.