- Joined
- Apr 1, 2014
- Messages
- 2
- Motherboard
- Motherboard OR System make and model names > See Forum Rules!
- CPU
- i5-12400
- Graphics
- RX 6600
- Mac
- Mobile Phone
Hi everyone, I have been stuck on this for four days still have no clue. Hope can get some help from here. I am using a pretty common hardware set up but I got stuck as soon as I boot from my USB to start installing Ventura 13.2:
I looked up for various messages online but without much luck. The one line interesting is this:
But my RX6600 as OpenCore said is officially supported since 12.1. The Device ID is 1002:73FF, which is what RX6600 and RX6600 XT have.
My hardware set up:
Basically I did every step the above tutorial instructed, especially the spoof CPU in the Emulate section and set the correct boot-args for my GPU. Now I am starting from scratch by using the OpenCore pre-built ACPI and latest minimal set of KEXT. I also tried a couple of pre-built EFIs dedicated for the motherboard but got the same symptoms.
Also the OC folder with config.plists is attached here. Any hints will be much appreciated, thanks!
I looked up for various messages online but without much luck. The one line interesting is this:
WhateverGreen igfx: @ found an unsupported processor 0x6:0x97, please report this!
But my RX6600 as OpenCore said is officially supported since 12.1. The Device ID is 1002:73FF, which is what RX6600 and RX6600 XT have.
My hardware set up:
- Intel 12gen 12400
- ASRock b660m-itx/ac
- PowerColor Hellhound RX6600
- G-Skill DDR4 32G
- SK Hynix P31 1TB with latest macOS compatible firmware applied
Basically I did every step the above tutorial instructed, especially the spoof CPU in the Emulate section and set the correct boot-args for my GPU. Now I am starting from scratch by using the OpenCore pre-built ACPI and latest minimal set of KEXT. I also tried a couple of pre-built EFIs dedicated for the motherboard but got the same symptoms.
Also the OC folder with config.plists is attached here. Any hints will be much appreciated, thanks!