Contribute
Register

Acer nitro vn7-591g very strange problem during installation

Status
Not open for further replies.
kubas121 said:
I tried all of them. Each gave me some interesting colorful buggy glitches :D but unfortunately none of them work. I found a tool that can dump it (https://pikeralpha.wordpress.com/2014/09/05/preview-of-appleintelframebufferazul-sh-v3-0/) but how do I run it if I have no access to osx system...? Seems kind of useless
Click to expand...

What kind of glitches are you getting? If they are just minor, there are other fixes you should investigate (eg. "9mb cursor bytes patch").

If they are major, maybe it is an EDID problem. You should post a photo to better explain what you're seeing.
 
Defianetely not minor:

IMG_20141230_232502.jpg
 
kubas121 said:
I get this this somehow to work. The setup is installing. What I did I used this conifg:
https://www.dropbox.com/sh/28spnh4o...kY7XBXLQwtAa/Config/HD4400:4600 1600x900?dl=0

suggested in this tutorial:
http://www.tonymacx86.com/hp-proboo...-install-yosemite-hp-laptops-clover-uefi.html

but all other files according to your tutorial. The problem so far is sometimes the mouse clicks are not detected and small graphics glitches (when moving window etc.)
Click to expand...

With that config.plist, you disable HD4600 graphics. You'll eventually need to figure out how to enable it, because OS X without QE/CI is very painful.
 
Yes. It's true. I installed the system sucesfully but in the overwiew it says that the graphics card has only 7mb :). I am gonna dump the ids and figure the way to make it work. How do I modify my config when I am booting installed osx from drive not installation from usb?
 
kubas121 said:
...How do I modify my config when I am booting installed osx from drive not installation from usb?
Click to expand...

I don't understand the question.
 
I still didn't fix the graphics issue because I first wanted to create dual boot.

I have one hard drive with osx and windows. I first installed osx then windows, then I created clover bootloader on hdd. Now the computer boots into clover but there is no windows visible :/. I am sure the windows was installed properly because after the installation it booted straight to the windows. I guess after installing clover bootloader it overwritten some information on EFI partiton that windows need or I don't know ;). Here are my partitions:
https://www.dropbox.com/s/bowmqr1nit7jp9w/IMG_20150101_201956.jpg?dl=0

I would be grateful if you could tell me how to make it visible in clover?
 
kubas121 said:
I still didn't fix the graphics issue because I first wanted to create dual boot.

I have one hard drive with osx and windows. I first installed osx then windows, then I created clover bootloader on hdd. Now the computer boots into clover but there is no windows visible :/. I am sure the windows was installed properly because after the installation it booted straight to the windows. I guess after installing clover bootloader it overwritten some information on EFI partiton that windows need or I don't know ;). Here are my partitions:
https://www.dropbox.com/s/bowmqr1nit7jp9w/IMG_20150101_201956.jpg?dl=0

I would be grateful if you could tell me how to make it visible in clover?
Click to expand...

You probably did not install Windows in UEFI mode. Make sure you boot the Windows installation media in UEFI mode to cause the Windows installer to setup in UEFI mode.
 
Status
Not open for further replies.
Copyright © 2010 - 2024 tonymacx86 LLC
Back
Top