Search results

Booting into the recovery partition and going into terminal to investigate better. Partition is unmountable but seemingly nothing is wrong with it when I run verifyVolume on it as seen below. Yet it fails to mount even if I try readOnly.

Yes it enabled in the BIOS and if I boot in windows I can see the extra ntfs partition on that M2 drive.

Oh great, I can't boot into this installation with my USB unibeast disk, not even in safe mode :( When I run the installer and boot into that, disk utility shows my OSX drive as unmounted and I can't even mount it back on.

Is there a way to disconnect a M2 SSD without physically removing it form the MB?

I had a dual booting system working with OSX on m2 ssd and Windows on Sata SSD. After windows installed some updates last night, I can't boot into clover and my OSX system and instead getting the error: "0:301 0:000 Not Found" when I select from bios boot options for my M2 drive to be primary. I...

Has anyone tested the latest security update 2019-002 on this setup?

Also I think the target folder is: "macOS Install Data" not "macOS install data". At least that's what I found on my side.

Moved this old box to mavericks yesterday. Mostly smooth update, thou I did have to boot with -x from unibeast 3.0

Used this guide and got my setup up and updated to 10.8.1 with all working smooth. Thanks for the guide. Anyone tried moving theirs up to 10.8.2 ?

Yup I just checked my Windows setup and it was also showing 2.0 Ghz which meant it wasn't OSX specific, so I checked the bios afterwards and sure enough it was set to 2.0 (x15) multiplier. I guess I never noticed that after flashing my bios it was dropped down to this value. Geekbench ?! I...

The information I get in the system profiler doesn't match my system (check signature). I did a clean install, update to 10.6.2 and ran multibeast with easy mode for 10.6.2 plus selected the DSDT for my motherboard. Shouldn't the CPU speed be 2.8 Ghz? Geekbench reports the same: 2.0 Ghz. Is...