yesbuffaloduets, thanks for your advice.
I booted using -f argument and then in terminal I run those commands:
sudo touch /System/Library/Extensions && sudo kextcache -u /
sudo touch /Library/Extensions && sudo kextcache -u /
but nothing changed
Trying to change clover boot option I...
Thanks for your answer BreBo, I do this but nothing changed. I tried also to find another copy of this kext in other directories or in the efi partition but with no success.
power management is still not working
Hi to all. After the installation of mojave using multibeast I checked by mistake "nullcpupowermanagement" option.
I need to re enable power management on my build; how can I do that?
I checked for nullcpupowermanagement kext on my S/L/E and inside my EFI but I hadn't found it.
Thanks as usual...
I just used your AML file and all ports works perfectly. The Hub and the SD card reader on my BENQ PD3200U monitor are correctly recognised. Speed of the card reader is not so high but this is a limit of the reader.
usually I keep connected a TS451-A QNap NAS via USB 3.0 port (speed is about 110...
Just installed the AML file, all ports works perfectly a very high speed.The Hub on my BENQ PD3200U monitor works fine and also the SD card reader bundled with the monitor word fine (speed is not very high but I think that this is an sd card reader limit; using my lexar pro reader the speed is...
and... one more thing... :-)
I have an USB3 hub inside my monitor connected to SS10. I need to discover all 4 ports located on my hub and than add those ports in to the DSL file or this is not necessary?
Thanks a lot CmdrX3, this is a very big help for me.
I have a question regarding 15ports limit: the rear top left port is marked as HS06 when used for USB2 devices and SS09 when connected to an USB3 one. This means that the same connector use two ports it isn't?
If for example I plan to use this...
I forgot...: tried to set on multibeast to patch ports and I also installed this...
but nothing happened
Dear all, I just finished my new build using this configuration:
MB - ASRock Z390 Extreme 4
CPU - I7 9700K
RAM 32GB @3200
GPU: Saphire RX580
Mojave 10.14.2 fresh install
All I need works fine (ETH, gpu etc.) but my USB 3.x ports don't recognise connected devices if the connected device is a USB...
Hi people.I just buyed a 4K thinkvision x1 display connected to my graphic card via DisplayPort.
Video card bios is updated, cable is high end but I have a problem. selecting resolution in the displays preference section os system preference I can get as native resolution only 1920x1080 and...
just made a fresh install of Mojave on my machine (Z87X UD5-h, 16GB RAM, I7 4770K, Nvidia GTX 970)
I was using Sierra because I had a lot of problems trying to install high Sierra; I had never be able to boot the installation program even with a lot of different configuration and bios settings...