Recent content by vinhnguyen1211

I came through many experiments & now able able to understand your reply. I don't have much knowledge in electrical, do you have suggestion how to / which equipment can create a 3.3V supply for the card? I'm really appreciate it

Thanks for the detail. I've tried to use GC-ALPINE RIDGE with Z490 Aorus but breadboard jumper isn't working. I've found that the pin of motherboard header isn't fit breadboard pin, it's smaller and not tight enough. I decided to order a brand new GC-TITAN RIDGE for further experiment...

I just try and it isn't working as expected. (I was using Z490 Aorus pro AX) I've checked over Thunderbolt config in BIOS and Windows (using HWInfo, it usually appear under Bus) it isn't show up. I also tried to connect 5 pin of Alpine card to 4 pin of 5 pin (beardboard cable was too tight to...

I have a dump question, is the procedure to plug female of breadboard cable to top pin and connect to middle pin? Sorry for dump question because this is first time I've attempted to do this.

Thank you CaseySJ! I’m able to find this cable on some online shop, do you have a url/guide how to start with it?

That's unfortunately. I think it will never get it fully work without Thunderbolt header cable. My mainboard is MSI B660M, and it has 16-pin connector instead 5 pin as Gigabyte.

I see the point now, it requires 2 DP-in while this card only have 1 input. IORegistryExplorer does show Thunderbolt connected. I tried connect to a real mac (m1 pro) and it said thunerbolt connected under Thunderbot section of real one. Too bad it isn't enough for the display. ------ I do have...

hello everyone, I've successfully setup this tb card (buyer said it was in some dell/AIO computer, titan ridge isn't available anymore in my area). It doesn't have tbt header cable to connect to my motherboard. it has 1 DP-in and connected to amd gpu. The problem is when it's connecting to...

I tried couple of days but still not figure it out. Anw, many thanks to you for helping me :thumbup:

I changed to iMac14,2 but it still wake up right after sleeping, maybe it really need to map USB I don't have EFI, kexts for clover boot :(

Thanks for the advice. I updated to iMac19,1 but it didn't resolve much. I'm trying to create USB boot, avoid doing directly from my hard drive EFI (I installed hackintosh on an individual ssd) but keep notifying this error no matter how I reload it Step I did to Format USB by disk Utility...

Thanks UtterDisbelief, I've checked my configuration: XHCI Han-off is enable. Here is my IORef and list of kext Also, this is my SSDT-UIAC

I'm using Intel 9260 includes Bluetooth adapter (connect through USB Power, Wifi on PCI.E slot). The problem is I've complied SSDT-UIAC and SSDT-EC-USBX but I afraid it will crash current EFI boot so I have not replaced SSDT-EC-USBX yet because the different was too large (SSDE-EC-USBX I'm using...

I've read but that topic didn't mention about bluetooth. I tried to plug - unplug bluetooth adapter to USB power but it doesn't change

Do you have an instruction for Opencore? I'm experiencing Bluetooth keep hackintosh awake right after sleep Many thanks :thumbup: