Recent content by verleihnix

As you can see in my screenshot USB3 is recognized, but attached USB 3.0 devices only work at 480Mbit/s. They should connect at 5Mbit/s.

Sorry, but I can't see any USB 3.0 device attached. And if there is one, it has to be at 5Gbit/s speed .

Thanks for sharing. Your dsdt looks very identical to my one. USB 3.0 Stick is recognized in system information, but it connects only at 480 MBit/s. Please check at your side.

Yes, I'll try it. Thanks

Hey jbamford, you have same mobo (z77-ds3h) as I do. I am struggling with USB ports. Do You have working USB 3.0 setup?

Yes, if I disconnect mouse and keyboard before sleep it doesn't wake before power button is pressed. That makes no difference. Is it possible to take the FW from the ASUS BT400 and load it into the Inateck? Maybe it depends on the FW version?

The other two devices, which won't work without BrcmPatchRAM.kext I wanted to point out that loaded kext cause the instant wake. Do you have a build were BrcmPatchRAM.kext is loaded, a BT mouse is paired during sleep, and you are able to wake it via mouse button.

Airdrop and Magic Mouse are working fine in that scenario

ASUS BT400 4096 without BrcmPatchRAM works fine. It sleeps and wake if mouse button is pressed. ASUS BT400 with BrcmPatchRAM 5563 wakes instant after sleep.

Yes, but why does it only wake if BrcmPatchRAM is loaded? Same BT device without BrcmPatchRAM stays a sleep till mouse button is pressed. I would like to figure out why it happens to use a finding where the kext is needed to make the BT device functioning.

11.08.15 17:56:39,000 kernel[0]: Wake reason: GLAN EHC2 11.08.15 17:56:39,000 kernel[0]: The USB device HubDevice (Port 1 of Hub at 0x1a000000) may have caused a wake by issuing a remote wakeup (2) 11.08.15 17:56:39,000 kernel[0]: The USB device BCM20702A0 (Port 1 of Hub at 0x1a100000) may have...

Is it a matter of BT FW or FW loaded by kext which causes the instant wake? From my point of view my builds don't have generally sleep issues. With the BT400 or a CSR 4.0 device it stays in sleep mode and it wakes by mouse key. If you disable "wake by USB" it wakes only by power button.

There is no item "Wake on USB" in BIOS. Is it possible to load firmware c4096 into devices? That is the one from the ASUS BT400 which is working fine without kext.

Hello, I have three devices Inateck (0a5c_21ec), ASUS BT400 (0b05_17cb) and Azurewave 4352HMB (13d3_3404). The BT400 works out of the box. It sleeps ok. The other two needs the kext. But with BrcmPatchRAM loaded all three wake instantly after sleep if magic mouse is connected. Without paired...

Hi pistooli, I bought same card. You flashed it with 8086:1E31. Which driver do you use? in 10.8.5 it does not work without additional driver. Regards