Recent content by tracert

In my case, without the boot flags, Lilu and WhatereverGreen don't work... Did you try using the boot flags in clover boot?

Successfully updated from Sierra to High Sierra. Only problem is the strange screen during the boot (screenshot attached). Problem solved using Lilu.kext and WhateverGreen installed with 'kexts utility'. Also necessary to add custom bootflags "-lilubetaall radpg=15" in Clover configurator

Fixed it!!! Lilu.kext and WhateverGreen was already installed but is necessary to add custom bootflags "-lilubetaall radpg=15" Now all works! :mrgreen:

Hi Guys, after the update to High Sierra I have some problem with my graphic card Shappire ATI Radeon HD7770 (see attached screenshot). I tried to use Lilu.kext and WhateverGreen.kext but with no change. With Sierra all worked fine. Now with HS I must boot in safe mode. Someone has an idea how...

I upgraded successfully from Sierra to High Sierra following the procedure. The upgrade Is ok but I have graphics glitches problem as you can see in the attached photo. After the apple logo in the screen appear these strange symbols. I used Lilu.kext, WhateverGreen kext (instead of Verde kext...

Hi all, I have a similar problem after the update to High Sierra with my Sapphire Ati AMD Radeon HD 7770. During the boot, after the apple logo, is shown the attached screen. Lilu kext is already inside the EFI/CLOVER/kexts/Other directory. Someone know if could be a good solution to install...

this means to re-install with USB pen drive?

strange, I used KextBeast as suggest from you to add AppleHDA.kext. How can I proceed now?

Can you check now if in this IOreg is present also AppleHDA? Thanks I hope I understand it well

Sorry toleda attached AppleHDA.kext

Ok. I use Kextbeast and put again AppleHDA.kext in S/L/E After that I removed the 4 zml files Attached alla files after the operations described before and the restart

Sorry toleda, I understood in this procedure that was necessary to remove the file AppleHDA.kext or the others single files. Is for this reason that I ask you before how to ricreate the native AppleHDA.kext file. MultiBeast 8.0+, remove: S/L/E/AppleHDA.kext and install the native...

files attached AppleHDA is not present because removed previously Thanks

I did this operations: 1- I removed S/L/E/AppleHDA.kext 2- I modify EFI/CLOVER/config.plist removing the three parts with AppleHDA as shown in the attached file 3- In L/E there is no realtekALC.kext but only RealtekRTL8111.kext. I don't removed any files 4- CloverALC -> S/L/E/AppleHDA.kext...

ok. Toleda, where can I take the native AppleHDA? The one that I have saved is obtained with Multibeast if I not wrong