Recent content by SplitGamer

Thanks a lot. Everything is working as expected now.

I mean that I can connect and use USB drives at these ports. 1. iPhone 12Pro / iOS 16.5.1 2.-6. I tried Apple USB, Apple USB-C and third party USB cables with no additional adapter. It is fully connected and asked me on both ports (USB / USB-C) if I trust this computer. But it does not charge...

Hi, my USB ports are working in general but my iPhone is not recognized when plugged into any of those ports. USB-Drives connect without problems. I do not know where to start fixing this problem. Do you have any advice. I'm running macOS 13.4.1 on OC 0.8.4 Thank you

Maybe there was an auto update which installed a new OS version which is not compatible with your bootloader anymore? Can you share some more information like which version of macOS and which bootloader do you use? Every bootloader comes with an option to enable a verbose mode during the boot...

Thank you for your response. Unfortunately removing RadeonBoost.kext did not bring any improvement, but I will compare your EFI configuration with mine later.

At the moment I'm only able to run my 5700XT GPU properly on 10.15.4. Upgrading to a newer version leads to a black screen during boot and shows an "gIOScreenLockState 3" error. Reading a lot of threads at the moment to figure out a working clover configuration. @gateway69: Are you running...

Hi @lele90, are you still on 10.15.4. or did you upgrade to 10.15.5. or 10.15.6.? My Radeon 5700XT worked until I tried to upgrade further than 10.15.4. Afterwards my monitor went black during boot and the error "gIOScreenLockState 3" is shown.

Hi @lg777, in your first post you mention that you use Catalina 10.15.6. Is that correct? When upgrading to 10.15.5. or 10.15.6. did you have to change anything in your settings to keep the Radeon GPU working? My system runs without problems until 10.15.4., but when upgrading to 10.15.6. I get...

It took me a little while, but I added the folder without the themes in my original post. Good luck

For me it was enough to just update most of my existing kexts to the latest version. Since I had serveral other problems I did nearly all of them but I guess FakePCIID.kext and FakePCIID_Broadcom_WiFi.kext did the trick.

I have documented all steps I did with my Sapphire 5700XT to get it up and running. Maybe it helps you too?!

Hi, I have spend the last few days getting my new Radeon 5700 XT fully running under macOS Catalina. Since I read many posts and tried a lot of different things I wanted to share my findings here, hope to help other users with similar problems. My goal was to get a two monitor setup running...