Recent content by SARCOM

Ok, I seem to be stuck ..... I walked through the guide, (Clover) and I am sure I have missed something .... I did copy the plist for a mixed system (SandyBridge and HD3000) I get to the Clover boot screen .... then select spacebar and -v selection choice and the following screen shot is...

I have been away for a few days, however I will work on this tonight... Thanks again

I am using Clover, Thank you for the pointer... I will go through the guide you posted.. Thanks again for the help

Here it is ..

Little more progress... Here is where I am at ... Screen Shot Wednesday 2

Ok, I kept working at it under Clover..... I get to the proper boot screen, however one I start the boot process... it goes to a circle with a line through it.. I ran it with -V and here is the screen shot The good news is that I have progress... ( I think ) Thanks again,

Here is the screen shot

I did as you suggested, picked up an new usb key and then walked through Clover. Everything seemed to be straight forward, however I seem to have failed at the same spot in boot.. I used the file CLOVER/config_HD3000_1366x768_7series.plist.webloc (This is for a HD3000 77 Series Board - mixed...

Thank you RehabMan, You were correct it is a HM77 I will work through the documents, and detail for a Mixed System.....I can't seem to figure out how this is completed.. Can I assume that I need to use your editor MaciASL to accomplish this... and edit the Info.plist file to include the two...

This is the info that should have been in my signature... I will get it set up.. Thank you for the help and pointers. System:ACER / ASPIRE S3 - 391 (Chimera) CPU: Intel i3-2377m CPU @ 1.50GHz + Intel Sandy Bridge Rev. 9 Graphics: Intel(R) HD3000, 1366x768

I did install that Kext. However since that then I started with a fresh USB Key and worked the process from the start. Happy to say I am moving forward .... Here is a screen shot thus far on the new USB Key. -V only at this point..

I have made progress, I did not correctly install the updated Kext. This is the current screen shot... I will keep working with it... If you see something with the screen shot feel free to tell me... I will go back through the guide and see what else I missed This was with a -V and...

Thank you for the info, I have walked through the process in the guide four or five times and still get the same result. I reformated each time and started over. I even used an alternate 16G USB ......I am sure I am missing a step in the process, however can't see it this evening. The -V shows...

Here is a Screen shot when it starts to hang ... I did remove The AppleACPIPPlatform.kext however I am still hung at this msg. If I had to guess it can't seem to find the USB drive I am still working through the document listed above, however seem to be stuck ... Thoughts? Thank you in advance

Thank you, I will work through it now ...