Recent content by nikezzz

Hmm maybe try this from SalPro Thread (maybe also with MacPro6,1):

Hm maybe try to disable the Onboard VGA via Jumper :problem: Ok so you tried both Slots? also do you use this PIKE RAID Card? Maybe try to remove this one However you'll need definitely npci=0x2000 (or 3000) and maybe PCIRootUID=1 (or 0)

Oh I didn't notice that you're using v2s then MacPro6,1 should be fine I think - you're geekbench score is awesome :clap: in which Slot is your 760? Try to use the 5th or if you're already in the 5th Slot and using a DSDT try the first Slot. Oh and be sure to activate IO Acceleration Technology...

@davidahn try to disable Hyperthreading as you are using 64 Logical cores with these Processors and Mac OS X doesn't support more than 32 Logical cores as far as I know ... Also try MacPro5,1 SMBios or MacPro6,1 and I would recommend clover because you might need the HaswellE Patch (onthefly)...

Hey cool thx will try that later :thumbup: try to use MacPro5,1 and web drivers - I get my GTX780 working that way (maybe also GraphicsEnabler=No for installation)

@dyphonix could you please share your wisdom on how to patch the kernel for cpus=31 fix? I'm currently trying to get 10.10.2 working and I'm stuck at cpus=31 again however the old kernel doesn't work

Yup put it in Kexts/10.10/

are you using the patched AppleIntelCPUPowermanagement.kext?

Did you enable Generate C-States and P-States enabled in your clover config?

change your bootflags to: -v kext-dev-mode=1 npci=0x2000 nv_disable=1 cpus=1 dart=0

again boot verbose (-v) for a screenshot - also use nv_disable=1 This will work but you can also use Toleda's AppleHDA patch for Realtek898

nope UEFI-Capable system and you need the aptiofix and memfix in Drivers64UEFI You also need to format your ESP as it is explained in Install Clover in the ESP. Later you need to swap the VBox.efi with HFSPlus.efi and you should use a config from r ampagedev (Asus X79 WS E should be good) Also...

arkanis and me are using clover because of progress :lol: seriously clover is a lot ahead of chameleon or chimera

You should use clover I can't guess what's the problem from the progress bar - boot with the flag -v

Hey chambitaboy, try to use clover and the flag nv_disable=1 - also put your 970 in the fifth PCIe Slot