Recent content by jsalzer1973

Glad I could help and that you're up and running. Welcome aboard! I love OSX, it is a paint sometimes to get it working on non-apple hardware, but well worth it.

See my instructions on this post: http://www.tonymacx86.com/mountain-lion-desktop-support/93425-complete-loss-will-not-pass-gray-load-screen-tried-everything-i-can-think-have-seen-already-tried.html#post576528 That's what I did on my end to make it work with my setup.

It was actually a Gigabyte GA-Z77X-DS3H motherboard and an i5 proc. Should be similar procedures I would imagine.

Well, I just installed 10.8.3 and used multibeast yesterday without any problems. Besides the fact that I have to use the dart=0 boot flag to boot when VT-d is enabled, everything works fine.

If you can't disable vt-d/vt-x try booting with the dart=0 flag.

I was able to boot with VT enabled on the BIOS but have to add the dart=0 boot flag... Anyway to permanently add this boot flag so I don't have to type it every time?

Disable VT on the BIOS and you should be able to boot without the -x

I got the same motherboard and got 10.8.3 to work. I did run into a road block, but was able to fix it. Here is what I did in detail: 1. Remove any hardware which is not necessary (additional network cards, Firewire, soundcards, USB headsets, etc) 2. If you have an ATI or NVIDIA graphics...

I was running 10.8.2 without any problems for months. Last Friday I decided to upgrade to 10.8.3, BIG mistake! Upon reboot my system did not boot. Nothing worked, except -x (safe mode). After extensive troubleshooting I pin-pointed the problem to VT being enabled on the BIOS. I disabled VT...

I also did a fresh install of ML and I am having the same problem with Multibeast Mountain Lion edition 5.0.2. It doesn't matter what options you choose, it always fails to installed. I actually did a fresh ML install on my desktop a few days ago and went without a flaw, however, I used the...

Article: UniBeast: Install OS X Mountain Lion on Any Supported Intel-based PC Are you sure both of your NICs are working fine? I was running fine under Lion, but then got a new motherboard and did a fresh install of Mountain Lion. I had the same issue where I could not connect to the...

Has anyone had luck with this laptop? I am able to get Mountain Lion installed following the Unbeast method, but after the install I can only get it to boot when using the -x flag. This brings it into single boot mode and the mouse doesn't work. I fumbled my way through doing multibeast...

I have a similar problem. I am installing ML on an ACER V3-771G, I was able to get ML installed without any problems using the Unibeast method with the GraphicesEnabler=no flag. The problem that I have is that after it reboots, I can only get ML to come all the way up with the following...

I've been running OSX on my desktop for about 2 years. I've been running Lion on my desktop without any issues now for about 6 months and can't wait for Mountain Lion. I recently bought an Acer Aspire V3-771G and would love to run Lion (and hopefully Mountain Lion when it comes out). Here are...