Recent content by htek41

I agree with this, although maybe Lake Tahoe as a slight variation.

I think that solved it. I made the changes using the instructions you provided, did a restart and everything now seems to be working properly. Thank you slim.jim for your responses and instruction. I think for now anyway I can call this issue resolved. Very much appreciated!

Ok so I have Clover Configurator downloaded and I've figured out how to change the system profile, but I haven't figured out how to make the change permanent. Is there some kind of guide on how the utility works? Or what is the best way to use the tool to make the change? I am going to change...

Thank you for the advice. Unfortunately MultiBeast fails when I try and change the system profile. It says the following I am using MultiBeast 8.1.0. Where can I find the log file that is referenced in the screenshot shown above? There is no Multibeast item or folder located in Library/Logs.

If I switched the system profile, would that eliminate the need to remove kexts? Or is that something that might need to be done anyway? Thanks!

How would I know if I have non-ECC RAM? I have Crucial installed, I think it is Ballistix version. How would I find the kext you mentioned also?

I have been experiencing a kernel panic/reboot loop after installing an EVGA GTX 750Ti (FTW). I have tried disabling the Nvidia graphics drivers using the "nv_disable=1" boot arg, but that has not worked. I am only able to successfully boot and get to the desktop using Safe Mode. I was able to...

Article: MultiBeast 6.4 Update I have a Gigabyte Z87-D3HP board. Everything updated fine, but once the computer goes to sleep… on wake the sound no longer works. After a re-start it is fine, until the next time it goes to sleep and is awoken again!! Frustrating!!!