Recent content by GreenWolf89

FOLKS, I just solved it! At least for me...I switched from running 1/4" - 1/4" speaker cables to 1/4" - XLR (XLR into monitors), and poof the noise went away!

Same here guys, same crackle/static, even with TwinX turned off, as long as TB3 cable connected. Tried redoing power configuration, managing cables, no luck...

Hey all, I finally got my UAD Twin X to work on the ProArt Hackintosh, HOWEVER, now the Twin is sending static fuzz to the Yamaha HS8 monitors. Def caused by Thunderbolt, not sure what's up, I've tried rewiring, moving stuff around, etc etc...anybody else have this issue?

Thanks for this - I updated my ACPI to include your posted AML, then did the ProperTree snapshot to update my plist, still no dice. When I install the UAD drivers, I get an error message in the Meter saying "Drivers Installed Incorrectly," and my Apollo is not showing up in Hackintool if I have...

Thanks...I can't get my Hackintool to even recognize the Apollo Device if it's plugged into the two TB3 ports on the back of the MB. Any chance you could post your EFI? I'm guessing I have something wrong in the ACPI or kexts, maybe in my plist config, would greatly appreciate it!

Hi there, any luck with TB3 ports on the back? I've gotten to the point you said in your initial post, trying to run Universal Audio Apollo Twin, but cannot get Catalina/ProArtZ490 to recognize the device. Thanks!

I was able to get my ProArt Z490 up and running Catalina through Open Core 0.6.0, BUT I cannot figure out to activate the TB3 ports on the back , hence making the one thing I want to do / make music using my Universal Audio Apollo TwinX impossible. Keep getting the error message "Thunderbolt...