Recent content by djwikka

I personally used the pi3b+ with the "cheap" soic8 flasher. The method that worked for me was: Disconnect power from motherboard (z390) Connect jumper wires as suggested via guide with PI off. When PI comes on, there will be amber lights on the board. - try to read, wont work. Remove 3.3v from...

Yes, used wrong MaciASL version. Fixed, replaced, and moved over the DROM info. Thank you!

Got it installed - and no read on the GPU. Everything else looks good. Do I need to configure anything for the GPU to be read? my iGPU is disabled in BIOS - not doing headless yet. When I run the config, it is not seeing the smcsuperio. It is in the kext folder.

MaciASL was the problem. You are the expert. I used one from elsewhere. I will modify my files using those. Thanks again for everything.

there it is... cannot compile with that first few things that is in the dL file - there are other things in there too that don't work "stock". I just started deleting until compile passed the test to save - did I delete anything important? lol - I can hot plug :)

AWESOME!!!!! MY CLARETT 4 PRE is GOOD TO GO. amazing work to all that made this happen. thank you for the clear guides!! @CaseySJ - there is some 898 in the beginning of the file that I had to remove - is it supposed to be there? the DSDTs? I've added the port7 and now have 40gb on the other bus...

Thank you for helping and explaining- I went ahead and ordered my TB3 to TB2 adapter and expect it to arrive this evening. Last clarifications: Does the tb domain uuid changing/inconsistent on reboot reflect any problems? Is it expected for the GPU temp not being recognized in iStats? How can...

so it is not recognizing it?

did not work, but I put a usb in - and it reads it. after reboot, the domain uuid changed for tb3 - is that expected?

It's a GIKERSY USB-C hub. it is more just to see if the system is recognizing it via the USB-C port. Is there a way I can change the settings for the GPU? Do I just to set idle at, say, 500RPM for comfort? :)

It wasn't quite "right away". I've been spending A LOT of time trying to figure it out. At one point I almost RMA'd the board as it is new because I thought I screwed it up when the TB3 disappeared from the BIOS settings and not recognized. But, after reflashing and positioning and flipping...

Yes, I think I changed the 2-9 and replaced the 5 indicated. Not sure if i needed to do more. I left off port 7 for process of elimination. Just don't want to invest in the TB3 to TB3 adapter unless I have it all going right, and the USB-C display dongle has me thinking that my USB-C ports...

Greetings. Please excuse me -as this is my first post. I have been following and am thankful for all of your help with these builds. issues: usb-c dock to hdmi not recognized (video doesn't come on) fans stop spinning after boot (rpm 0 at idle) thunderbolt configuration. please let me...