Recent content by builtospill

Yeah, I've about replaced everything back in 2015/2016 to no avail. I still use this hackintosh as a work computer for Adobe lightroom and photoshop work and it still works perfectly in 2020. When I power up the computer and it just goes to black screen I just hit the reset button and it boots...

Yeah, I removed graphics card but havn’t tried boot args. How do I format that “ig 0x0a260006” arg, Just copy that how you typed it or is it missing underscores, etc? You removed both of the nvidia arguments? Also, leave dart=0 arg?

It shows iMac14,2 Boot args are set as dart=0 nv_disable=1 nvda_drv=1 ^^These are the defaults, I never touched boot arguments

It showed iMac 14,2 on the install USB in Clover configurator. I'm not sure what you mean in the Clover menu, like in the boot loader screen I can see that somewhere before booting into the installer?

No, like an unexpected crash reboot, I never make it past the first 20 seconds or so after I tell the High Sierra installer the destination install disk and the progress bar/install process starts. After the unexpected reboot, the installer launches again and gives me an error, I posted...

Also removed GTX 680 graphics card and ran off motherboard graphics and installer reboots still.

Yeah, just the USB installer plugged into a usb 2.0 port and the hard disk I’m installing to. No other drives hooked up. Also just tried re-downloading High Sierra and re-made the installer in Apps folder in Terminal, re-made USB installer in Unibeast. High Sierra installer still reboots moments...

No luck there. Replaced existing apfi.efi with the 10.13.5 apfs.efi, High Sierra install restarts same exact point.

I have not done that. Just simply click and drag that to drivers64UEFI foldrr in the mounted EFI partition on the High Sierra USB installer?

I used Unibeast 8.3.2 Just mounted the EFI and opened the config.plist off the High Sierra installer USB and the SMBIOS does show iMac 14,2 under product name

So I created the High Sierra USB thumb drive installer on an El Capitan system with iMac 14,2 set as system. However I just tried booting the El Capitan hard drive with the High Sierra USB thumb drives's Clover boot loader and the system report showed computer as a Mac Pro 3,1. Do I need to use...

Getting a random reboot in the High Sierra installer after I select the target install drive and it begins to install data with the progress bar usually 15 seconds in or so. After reboot the installer comes back up and I get error: "An error occurred while loading the the installer resources" I...

Recently RMA'ed i7 4790K and installed brand new one from Intel. Now I noticed sleep stopped working. Only the monitor falls asleep and wakes, system fans still running. Running 10.11.3 and Clover. Any ideas how to get sleep back?

I think the H100i v2 has the fan control built into the pump (even without Corsair Link). You just plug in the 3 pin pump power to the CPU fan port on the board and the 4 pin fans to the pump. Test the system under load and see if the fans speed up. Either way the fans and pump are running so...

I've had TRIM enabled on my 500gb Samsung 850 EVO in El Capitan 10.11.3 since new build in January with no issues.