Recent content by brookheather

Yes I had the same problem with my DW1820A card. I changed my wireless access points this week and wondered why I could no longer see the 5GHz network - found this thread and just changed the channel from 36 to 44 and now working fine again. My old wireless access points were using higher...

Only the DisplayPort output worked for me on my B360M DH3 motherboard.

Hi - I have a similar setup with a Gigabyte B360M DH3 motherboard and Intel Core i3-8100 processor with UHD 630 graphics and a QHD monitor connected via DisplayPort. Does sleep/wake work on your machine as on mine it crashes a few seconds after the screen goes dark and reboots. I am using the...

Have you installed Clover and selected this option: Bootloader - Install boot0af in MBR Is your boot set to UEFI or Legacy in the BIOS?

Try updating your kexts to the latest versions - your NvidiaGraphicsFixup.kext is an older 1.2.2 version for example.

If you change standby to 0 (sudo pmset -a standby 0) then sleep should work - it just won't go into the lower power standby state.

GT630 is a low end card - similar passmark score to HD4600 so I wouldn't bother using it.

Why are you wanting to use the GT630 - it's not much faster than the HD4600 iGPU? You should be able to use both DisplayPort outputs with the iGPU - just use a DP to HDMI adapter for the second display. For Bluetooth are you using Ethernet or a wireless card? If Ethernet just add a USB dongle...

Missing apfs.efi?

Try this to prevent standby mode after a long sleep - I use the same for my HP 800 G1 USDT - it means it won't enter the very low power standby mode but should resume fine after sleep: sudo pmset -a standby 0

Did you prevent APFS from being used? If not then you need to copy the apfs.efi file to Clover Drivers64UEFI folder - this is needed for Clover to see and boot from APFS formatted drives.

I upgraded one of my builds last week from Yosemite directly to High Sierra using the downloaded full installer - no real issues apart from needing to install apfs.efi as I use an SSD - you won't need to worry about that as you don't have an SSD. You can upgrade your Clover version before...

Have you copied apfs.efi into your Clover Drivers64UEFI folder - this is needed for Clover to see and boot from APFS formatted drives.

I downloaded this driver and it worked fine on my "Mac" with OSX 10.13.4 installed: https://rehmann.co/blog/wp-content/uploads/2017/12/MacOS10.9_MacOS10.12_Driver.zip

Now waiting for driver for 14F2109.... should have waited to update the OS!