Recent content by beatnaph

Thanks for the tip about SleepAid, I will give it a try and see if I can track down what's occasionally giving me issues. About the graphic switching, I'm used to the short switch like you mentioned, but in this case it was taking some 30 seconds of blank idle active screen after the switch. I...

Has anyone with this build upgraded to Ventura ? I did a few weeks ago and it works kinda ok, besides some sporadic issues waking up from sleep (not really reproducibles, most of the times it can sleep and wake up normally) and a very weird thing happening on boot: Progress bar goes 1/3 in, then...

Thanks, I didn't knew it was so widespread and acknowledged. Looks like picking up another Samsung 970 wasn't a good idea so.

Hello everyone! I have this build and yesterday updated succesfully to Monterey 12.3 from Big Sur. Previously updated OpenCore to 0.79 and the latest Lilu/Whatever/Alc/etc and did a full mirror backup to a second NVME using CCC "legacy bootable copy", which was something i didn't tested yet...

@ed.stein i was finally able to do a proper port mapping without the need of USBInjectALL.. When i disabled USBPorts.kext and applied the XHCI port limit Hackintool could see the full set of ports, even though many of them didn't actually work. But knowing beforehand which one i needed was...

I think i did a mistake .. If HS01 AND SS01 are from the same physical USB3 connector, type should be USB3 on both right ?

Fair enough :) thanks a lot for pointing me in the right direction, much appreciated

Nice point, does this seem to be more correct ?

Well, i somehow managed to fix it: I noticed Hackintool already displayed all the available ports beyond the 15 limit without USBInjectAll, even though some of them didn't work because falling out of the range. I recovered an old .ASL file containing the mapping of the ports i did in Clover, so...

Thanks both for the reply. I didn't have success with the suggested method, adding USBInjectALL to the existing configuration seem to totally break my USB setup, at the point that it can't detect any device. @ed.stein your EFI folder already contains a USBPorts.kext, i tried both leaving it...

Hello !! I've been using this build with Clover since a few years and decided to finally switch to OpenCore / Big Sur. I did a try with @ed.stein EFI folder on an USB drive and got a proper boot, so decided to use it on my main drive and update to Big Sur. So far almost everything works...

Today, I decided to make the switch to Catalina using this build. After the obvious update of Clover and kexts to the latest revision, I found myself unable to boot into the install because of error AE_NOT_FOUND (20160930/dswload2-274) Some research showed me that USB power property injection...

@Stork , @pastrychef thanks for your feedback. Now that I have a Thunderbolt 3 cable in my hands, I can confirm. Target Disk Mode works perfectly if connected with a TB3 cable to the USB-C of the Asus Maximus X. MacBook starts up with both TB3 and USB icons floating around the screen, then finds...

Hello, I've been using this build for a bit more than a year now, everything is perfect except for a recent problem which is bothering me.. The USB-C connector (ASMedia) on the motherboard works correctly if i put an USB-C hub in it and then plug some USB devices. BUT, I cannot connect a new...

I had the same doubt. I only managed to find one of those supposed "lite" rx580. what's different is the part number: Lite is usually 11265-06-20G while the old one is 11265-05-20G. You can see both version under specifications on...