Recent content by BadKarma

EVGA issued me a RMA for the card thus I will be replacing it once it arrives.

The system boots to the desktop fine. Just only one out of two monitors work. After messing with different ports, I discovered that only the top two work in OSX. Originally I had plugged into one on top and one on the bottom. Using only top two DVI ports gives me two monitors. Great news, but...

Changed smbios to MacPro3.1, didn't work. Still just one GPU EVGA GeForce GTX 590: Chipset Model: EVGA GeForce GTX 590 Type: GPU Bus: PCIe PCIe Lane Width: x16 VRAM (Total): 1536 MB Vendor: NVIDIA (0x10de) Device ID: 0x1088 Revision ID: 0x00a1 ROM Revision: 70.10.37.00.90...

Okay, will give that a try. Thank you.

Yes, I have Inject/Nvidia/True

Successfully installed Nvidia Web Driver 364.03.03f02 and added nvda_drv=1 to config.plist, but still stuck with 1 GPU. Please advise.

No, simply because I must have misunderstood that it only applies to newer Nvidia cards. I will give that a try. I've been going over your thread below. http://www.tonymacx86.com/graphics/161256-solving-nvidia-driver-install-problems.html Great job explaining and thanks for the suggestion...

Hoping for some assistance in getting OSX 10.11.1 to recognize the second GPU on EVGA GTX 590. Currently using only Inject-Nvidia via Clover with smbios - iMac12.2 Please advise if there's anything else I can include to assist in solution. Thanks in advance.

I'm a bit lost. I had applied the Enable Audio ID: 1 patch from your repository using MaciASL to my DSDT. Followed your Guide "How to Add or Edit dsdt/HDEF v2" and verfied HDEF layout id is "01 00 00 00" in IORegistryExplorer. However it shows as HDEF@1B. Is that a problem? If so, how can I...

I too lost audio upgrading to Yosemite from Mavericks. Had installed ALC AppleHDA 889 from Multibeast 7.0, but no joy. Looking for some help. OS X version: 10.10 Yosemite MB: EVGA Z68FTW BIOS Version: R22 (PM-Patched) CPU: i7 2600K GPU: EVGA 570 GTX Enclosed is a copy of my...

If I understand you correctly, you are attempting to install OSX Mavericks via USB at the moment. You should follow the instructions below: http://www.tonymacx86.com/374-unibeast-install-os-x-mavericks-any-supported-intel-based-pc.html No need to patch your BIOS during this process, if at...

The ethernet on your motherboard Marvell 88E8057 is not compatible with OSX. You will need to purchase a compatible add-on card (ie. PCIe) for internet. I had to do the same. Went with a STLab N-312 PCIe Gigabit LAN Card. OOB.

Bump. Seasons' Greetings to all.

Greetings, I have the following message displayed during boot I was able to find a DSDT patch that is supposed to address this error, however I'm not sure how to make it work for my DSDT, which does not contain _ADR, 0x001D0007. Patch: # Fix for "AppleUSBEHCI::CheckSleepCapability -...

Yeah. Actually been learning a lot from the experience. As it turns out, what was preventing my computer to shutdown properly was I did not install EvOreboot.kext from Multibeast, since I had a DSDT, however it was necessary for my system. My mistake, it had nothing to do with appleLPC.kext...