- Joined
- Jan 3, 2011
- Messages
- 49
- Motherboard
- Gigabyte Z390 Designare
- CPU
- i9-9900K
- Graphics
- RX 590
- Mac
- Mobile Phone
Hi @CaseySJThe Z590 Vision G and Z590i from Gigabyte are very similar, so ochang's EFI is a good starting point. The USB map is the first thing to customize. It can be done by following this guide:
Once that's out of the way we can tackle any subsequent post-install issue. For example, if the Ethernet port is not working or HDMI audio is not working, etc. those can be addressed one by one later on.The New Beginner's Guide to USB Port Configuration
Important Update: June 2023 From Big Sur 11.3 on the built-in OpenCore XhciPortLimit quirk no-longer worked as described. This became a known "bug", though in reality it was Apple changing their internal code, making a simple "peek and poke" to keep it operating, a difficult task. However, with...www.tonymacx86.com
At this time it's probably best to stay with the original Thunderbolt firmware. Hot plug should work with most devices once the Maple Ridge Thunderbolt SSDT is installed.
I'm still willing to experiment with activating Thunderbolt Bus via SSDT-TbtOnPCH, but this can wait until the system is fully configured.
I tried @ori69 EFI and had some problems with the USB and my TB equipment didnt show up.
Weird since ori has it working on his system.
I managed to make my own USB Patch,and now thunderbolt shows as expected.(No Hotplug yet,I tried the Mapple Ridge patch from you)
Here some files i extracted IOReg/Macaisl and Hackintool PCI
I also attached my EFI. just to check if al is good. and proceed from here.
I use a RX 580,i didnt do anything for igpu patching.
Thanks.