Anyone could make their HD630 work in Mojave?

[mendozal]

Anyone could make their HD630 work in Mojave? (i7-7700K)
I have a Titan X Pascal w/o acceleration and I wanted to try the 630. I get black screen every time.
In High Sierra the 630 worked with my current configuration. I have -disablegfxfirmware in clover 4674

 

[Superbogey]

Anyone could make their HD630 work in Mojave? (i7-7700K)
I have a Titan X Pascal w/o acceleration and I wanted to try the 630. I get black screen every time.
In High Sierra the 630 worked with my current configuration. I have -disablegfxfirmware in clover 4674

I've got almost the same MB as you do and did the same thing. I originally installed Mojave with my GTX 1060 running and thought I'd switch over to the internal graphics afterward for better video response. Booted into the BIOS, tabbed over to the Peripherals page with the Initial Display Output setting and switched it to IGFX, saved the settings and rebooted while I swapped the HDMI cable from the video card to the motherboard. It then took a little longer for the login screen to appear and almost hit the reset switch thinking I got a black screen. Unfortunately, once I did log in to Mojave, it wasn't any better on the HD630 than with the Nvidia card. Graphics were tearing and shimmering worse than the 1060 so I just reversed what I did and went back to my Nvidia card. I'll either tough it out until new drivers come out or bite the bullet and get at least a RX560 to eliminate that headache. I'm at work but will check if I have -disablegfxfirmware set in Clover when I get home.

 

[TravelerTechie]

Anyone could make their HD630 work in Mojave? (i7-7700K)
I have a Titan X Pascal w/o acceleration and I wanted to try the 630. I get black screen every time.
In High Sierra the 630 worked with my current configuration. I have -disablegfxfirmware in clover 4674

I have it working great. Even done some 4K video editing on the HD 630.

On BIOS I put it to Auto for IGFX Enable, and then there’s also choosing the main graphics card, I chose the IGFX. I am also running the latest Clover, and switched the HDMI cable to the motherboard.

Let’s hope Nvidia releases those drivers soon.

 

[Khaibit]

Works fine here. I use Lilu and Whatevergreen, and have specified my port setup as detailed in [Guide] Intel Framebuffer patching using WhateverGreen to match my actual board (1 HDMI, 1 DP port). Sleep crashes on wake, but from what I understand that cannot be fixed on the 5xx and 6xx Intel graphics. -disablegfxfirmware is not used.

 

[sbeaber4]

I have it working great. Even done some 4K video editing on the HD 630.

On BIOS I put it to Auto for IGFX Enable, and then there’s also choosing the main graphics card, I chose the IGFX. I am also running the latest Clover, and switched the HDMI cable to the motherboard.

Let’s hope Nvidia releases those drivers soon.

Would you mind posting your config.plist So I can compare. I appreciate it.

 

[anibalin]

Would you mind posting your config.plist So I can compare. I appreciate it.

I'm on the same boat. Thanks in advance.

 

[Superbogey]

Would you mind posting your config.plist So I can compare. I appreciate it.

Your specs say you're running with HD-3000 graphics. That's no longer supported under Mojave.

 

[mpvescio]

My HD630 worked w/o any changes on updating from HS. Only issue I've been experiencing is with my 2nd monitor (1x DVI works fine). The 2nd monitor (same model as 1st but connected via HDMI) has some really weird color shown on the screen. Almost as if there was an issue with the wire but after having replaced the wire I've ruled that option out. Its not a monitor problem and more likely an issue with the HDMI or dual monitor. Thoughts?

 

[Khaibit]

My HD630 worked w/o any changes on updating from HS. Only issue I've been experiencing is with my 2nd monitor (1x DVI works fine). The 2nd monitor (same model as 1st but connected via HDMI) has some really weird color shown on the screen. Almost as if there was an issue with the wire but after having replaced the wire I've ruled that option out. Its not a monitor problem and more likely an issue with the HDMI or dual monitor. Thoughts?

Which ig-platform-id are you using? Some of them specify 3 DP ports, or a DP port, an HDMI port, and an LVDS (internal laptop screen port) for example, and you may need to patch the framebuffer to indicate your actual port setup. https://www.tonymacx86.com/threads/guide-intel-framebuffer-patching-using-whatevergreen.256490/

 

[mpvescio]

Which ig-platform-id are you using?

Where would I find this? I actually just updated to Clover 4658 from RehabMan and my HD630 Graphics went from 1500~mb of memory down to only 7mb making everything very ugly.