To disable SIP and therefore be able to run the script, go into Clover Configurator, then in the sidebar select "Rt Variables," and over on the upper right you should see, "CsrActiveConfig" below a box that says "0x[some number]." Change whatever number is in the [some number] spot to 67 so the box reads, "0x67" and System Integrity Protection will be disabled after you save and restart the computer. That should enable you to run the script if SIP was preventing it.
Hi Cceptus, Thank-you for replying, and with a well explained step-by-step "guide". However, I think my config.plist file is broken. When trying to open in Clover Configurator (v4.33.0) i get an internal error. An older version from a couple of steps back opens fine.
So i did the following:
1) Replaced the current config.plist file with the one from before i removed the fixes (as per toledas post "Fix: 2. CLOVER/config.plist/ACPI/DSDT/Fixes/NO (all or remove)").
2) Opened config.plist ("new" one) in Clover Configurator, and went to rt Variables, and entered 0x67 in the box for CsrActiveConfig.
3) Rebooted.
4) Ran the cloverALC120.command again.
5) Rebooted
At this point, the audio was the same, only network devices.
6) Opened config.plist in Clover Configurator.
7) Removed ALL the "fixes" (both on "Old Way" and "New Way" tabs).
8) Re-Run cloverALC120.command.
9) Rebooted again.
Still the same, the only audio devices are Network. (or an USB Mic that works too)
FYI Toleda, I assume adding the 0x67 "fixes" the SIP issue, still no joy.
I have attached the files again...
Again Thanks in advance.