- Joined
- Jul 20, 2014
- Messages
- 1,074
- Motherboard
- AsRock X299 Creator-1.50
- CPU
- i9-10900X
- Graphics
- RX 6800 XT
- Mac
- Mobile Phone
hello
I've Try two more steps :
1 -Activate the USB 3.1 (type A). the documentation says it's an Intel controller
I activate it in the bios (3007) nothing appears when disk is plugged-in.
I can't find any info about what you try
2 - Activate the thunderbolt via Thunderbolt Dual EX Card
In the Bios plenty of setting but nothing more than without the card - no name of the controller mentioned
I booted with windows and install the drivers. then I plug an firewire adapter.
In the bios again, nothing change - still no name of the controller mentioned
I've try to boot with el Capitan in verbose mode : error allocating - most of the time
If I deactivate the thunderbolt in the bios - back to normal without the Thunderbolt capabilities.
When I succeed to boot, The info system -> thunderbolt sees the drive and the blackmagic video capture device, but Disk utility doesn't see the drive and the desktop video doesn't see the capture device.
I've try many BIOSi parameter possibilities, none was stable (i.e. 2 boots give the same result)
I've even try to disable thunderbolt (not fully) and enable it for PCI card (no parameters).
I will also try with a thunderbolt EX3 soon wich is recommended by ASUS
Any suggestions ?
Thanks in advance
I've Try two more steps :
1 -Activate the USB 3.1 (type A). the documentation says it's an Intel controller
I activate it in the bios (3007) nothing appears when disk is plugged-in.
I can't find any info about what you try
2 - Activate the thunderbolt via Thunderbolt Dual EX Card
In the Bios plenty of setting but nothing more than without the card - no name of the controller mentioned
I booted with windows and install the drivers. then I plug an firewire adapter.
In the bios again, nothing change - still no name of the controller mentioned
I've try to boot with el Capitan in verbose mode : error allocating - most of the time
If I deactivate the thunderbolt in the bios - back to normal without the Thunderbolt capabilities.
When I succeed to boot, The info system -> thunderbolt sees the drive and the blackmagic video capture device, but Disk utility doesn't see the drive and the desktop video doesn't see the capture device.
I've try many BIOSi parameter possibilities, none was stable (i.e. 2 boots give the same result)
I've even try to disable thunderbolt (not fully) and enable it for PCI card (no parameters).
I will also try with a thunderbolt EX3 soon wich is recommended by ASUS
Any suggestions ?
Thanks in advance
