Updating clover ended in black screen.

[Giorgos241]

maybe, but your image has cut the bottom of the screen

using hdmi?

Yes. I am using HDMI directly connected to the motherboard since I am using HD630 graphics

 

[Giorgos241]

The last thing that gets printed before my screen stops receiving any signal.
Weirdly, it looks like my USB headset detected the OS and boots up normally.

Too bad that new OSX versions don’t make a “pop” sound when you increase / decrease the volume.
It could have been a good teller on the status of the boot.

 

[Feartech]

The last thing that gets printed before my screen stops receiving any signal.
Weirdly, it looks like my USB headset detected the OS and boots up normally.

Too bad that new OSX versions don’t make a “pop” sound when you increase / decrease the volume.
It could have been a good teller on the status of the boot.

yes, it appears to be a graphics issue

make sure dvmt is set to 64MB in your bios

 

[Giorgos241]

yes, it appears to be a graphics issue

make sure dvmt is set to 64MB in your bios

Changed to 64mb did not solve the issue.
I’ll try lower a lower value.

 

[Feartech]

Changed to 64mb did not solve the issue.
I’ll try lower a lower value.

needs to be at least 64MB or 128MB sometimes for higher than 1080p

 

[Giorgos241]

needs to be at least 64MB or 128MB sometimes for higher than 1080p

Noted. Would it be possible that I screw up the EFI configuration?
It looks like I followed the guide.

Also I saw multiple report files on my USB drive.
I am attaching my EFI and the last log file I found on my drive.


EDIT:
Added darkwake=0 on my config arguments and now I was able to boot the installer. It’ll take forever, (it says 1:24 hours). I’ll wait and see how it goes since I’ll installl it on a test drive first

 

[Giorgos241]

Noted. Would it be possible that I screw up the EFI configuration?
It looks like I followed the guide.

Also I saw multiple report files on my USB drive.
I am attaching my EFI and the last log file I found on my drive.


EDIT:
Added darkwake=0 on my config arguments and now I was able to boot the installer. It’ll take forever, (it says 1:24 hours). I’ll wait and see how it goes since I’ll installl it on a test drive first

I have a weird bug.
In order for the display to start picking up a signal from my PC, I need to switch the input (from HDMI 1 to 2). HDMI 1 is the only input used on my display.
When selected, it says no signal.
When I try switching from 1 to 2, the monitor outputs the no signal message for 2 secs and then the software is displayed normally in HDMI 1.