The installation failed.

[ahmedmahdi12]

I recently ordered the snow leopard disk from apple. After running iboot for haswell I installed snow leopard and attempted to install multibeast though after i was done it told me to restart so I did and when i opened up again it told me to restart again. I formatted my hard drive and installed sl again and i didnt use multibeast this time. I had my Ethernet cable plugged in and it worked though safari didnt respond when i went to tonymac so i downloaded fire fox. I downloaded mavericks and unibeast and formatted my usb. When i ran unibeast and went through the process it told me that "The installation failed." and told me to contact the software manufacturer for assistance i tried again multiple times and it didn't work.

I have a i74770k, gigabyte h87m-d3h mobo, 8gb corsair vengeance ram, and 8gb kingston usb. I don't have a graphics card i use integrated graphics.

 

[Obvious Answer Man]

Did you read these two topics before posting?

http://www.tonymacx86.com/unibeast/102443-unibeast-troubleshooting-notes.html

http://www.tonymacx86.com/unibeast/85364-unibeast-failure-reporting.html

 

[ahmedmahdi12]

13-12-19 2:13:26 PM Installer[205] <ZeroSliderSplitView: 0x1006644b0>: the delegate <TargetSelectPage: 0x100662890> was sent -splitView:resizeSubviewsWithOldSize: and left the subview frames in an inconsistent state:
13-12-19 2:13:26 PM Installer[205] Split view bounds: {{0, 0}, {402, 104}}
13-12-19 2:13:26 PM Installer[205] Subview frame: {{0, 0}, {0, 32}}
13-12-19 2:13:26 PM Installer[205] Subview frame: {{0, 0}, {402, 104}}
13-12-19 2:13:26 PM Installer[205] The outer edges of the subview frames are supposed to line up with the split view's bounds' edges. NSSplitView is working around the problem, perhaps at the cost of more redrawing. (This message is only logged once per NSSplitView.)
13-12-19 2:13:39 PM Installer[205] The Installer encountered an error that caused the installation to fail. Contact the software manufacturer for assistance.